Model-specific code library

Maytag washer Display and signals codes

10 printed codes in this group: Beeping and Audio Tones, CL Code, Done Light On, Err, F0E1, Int, Lid Lock Flashing, LoC, rL, SUD.

Front-load washer with a closed door, a lit digital display and a padlock symbol above a row of buttons, under oak cabinets
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Display and signals codes

Beeping and Audio Tones

On a front-load washer, the entry for Beeping and Audio Tones says “These sounds are cycle signal tones that are part of normal operation.” Nothing else is printed, so schedule a visit if it repeats.

Information only
CL Code

On a front-load washer, the entry for CL Code says “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.

Information only
Done Light On

Maytag's top-load washer page words Done Light On like this: “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.” Nothing else is printed, so schedule a visit if it repeats.

Information only
Err

On a front-load washer, the entry for Err says “Err - Error Message.” Cut the power for five minutes, then restore it; schedule a visit if the code is still there.

Reset, then book
F0E1

On a front-load washer, the entry for F0E1 says “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.” No reset is printed for it, so schedule a visit if it keeps appearing.

Information only
Int

For a Maytag front-load washer, Maytag's page for Int says the cycle was paused or canceled. To reset it, keep the power to the unit cut for 5 minutes before restoring it. Arrange a technician visit with us if the display shows it again after the reset.

Reset, then book
Lid Lock Flashing

The Maytag page for Lid Lock Flashing on a top-load washer states “Some models will lock immediately, while others will not lock until after the wash cycle has started.” Nothing else is printed, so schedule a visit if it repeats.

Information only
LoC

LoC on a Maytag front-load washer: Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond. Nothing here is a repair order; schedule a visit only if it will not clear.

Information only
rL

Maytag's front-load washer page words rL like this: “This error code indicates that items were detected in the washer during the Clean Washer cycle.” Try the five-minute power-off reset, and schedule a visit if the code returns.

Reset, then book
SUD

Maytag's front-load washer page words SUD like this: “Sud or Sd is displayed:.” No reset is printed for it, so schedule a visit if it keeps appearing.

Owner checks first

Let’s take care of it.

A full hamper waits for no one.
Book the repair.