What it means
LoC on a Maytag front-load washer: Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond. Nothing here is a repair order; schedule a visit only if it will not clear.
Maytag washer LoC / Display and signals
LoC on a Maytag front-load washer: Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond. Nothing here is a repair order; schedule a visit only if it will not clear.
Also printed as LoC
LoC on a Maytag front-load washer: Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond. Nothing here is a repair order; schedule a visit only if it will not clear.
Copy LoC down as the display shows it, capitals and dashes included, and note the product type: front-load washer.
LoC stays lit although the condition above has passed.
Your Maytag to-do list, saved here on this device

Copy LoC down as the display shows it, capitals and dashes included, and note the product type: front-load washer.

Note when it appears and whether anything changes after you cancel the cycle or set the product down for a few minutes.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond.
Read the supporting manualNo reset interval is printed for it.
Read the supporting manualSchedule one with us if LoC stays lit although the condition above has passed. Have the exact display wording and the model number ready.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-06-04; PH 14584 / PH 14584 (front-load washer)
Scope: Maytag front-load washer. Source pages: Maytag Product Help, PH 14584, checked November 2026.
Maytag's page says it reminds you that Control Lock is on and has to be released before the controls respond.
No reset interval is printed on the page. Note when the message appears, and schedule a visit if it will not clear.
No part is named on the page. It describes the condition and what you can do about it.
Schedule one if LoC stays lit although the condition above has passed. Until then, the steps above are all the page asks of you.
Maytag codes, symptoms, parts and service
F9E1 reads differently by product type: the front-load washer page states its title reads Long Drain Time; the top-load washer page states its title reads Long Drain. Arrange a technician visit with us if it will not go away.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.