What it means
Maytag's top-load washer page words Done Light On like this: “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.” Nothing else is printed, so schedule a visit if it repeats.
Maytag washer Done Light On / Display and signals
Maytag's top-load washer page words Done Light On like this: “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.” Nothing else is printed, so schedule a visit if it repeats.
Also printed as Done Light On
Maytag's top-load washer page words Done Light On like this: “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.” Nothing else is printed, so schedule a visit if it repeats.
Power and water off before any panel comes off; towels down for spills.
Done Light On returns, or the top-load washer behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Check that your appliance is a top-load washer and copy Done Light On exactly as the display shows it.

Maytag prints no reset for Done Light On, so record what the washer does rather than guessing a fix.

Write down the model and serial numbers and the exact Done Light On wording before you call.

Note when Done Light On appears: at start, mid-cycle or after a power cut.
Write down the model and serial numbers and the exact Done Light On wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Done Light On is covered by this wording on the top-load washer page: “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.”
Read the supporting manualNo reset is printed for Done Light On on the top-load washer page. Writing down what the washer does around the code is the useful thing to do.
Read the supporting manualThe top-load washer list prints Cycle Complete Light On next to Done Light On, but with a different line. Look up the one on your display.
Read the supporting manualWhen in doubt, switch the top-load washer off. Never open a panel on the top-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-04-15; PH 14707 / PH 14707 (top-load washer)
Done Light On comes from Maytag Product Help (PH 14707) for the top-load washer, read in November 2026; the Done Light On entry names no models.
The top-load washer page reads “When the cycle has finished, the 'Done' light will illuminate, indicating the completion of the cycle.” It prints nothing more about cause.
The page prints none. Write down what you see and schedule a visit if Done Light On keeps appearing.
Not by itself; the page stops at the line it prints.
The model number, what Done Light On looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
For a top-load washer showing Cycle Complete Light On, Maytag prints “It will remain on until the lid is opened or cancel is pressed.” Nothing else is printed, so schedule a visit if it repeats.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.