What it means
For a top-load washer showing Cycle Complete Light On, Maytag prints “It will remain on until the lid is opened or cancel is pressed.” Nothing else is printed, so schedule a visit if it repeats.
Maytag washer Cycle Complete Light On / Door and lid
For a top-load washer showing Cycle Complete Light On, Maytag prints “It will remain on until the lid is opened or cancel is pressed.” Nothing else is printed, so schedule a visit if it repeats.
Also printed as Cycle Complete Light On
For a top-load washer showing Cycle Complete Light On, Maytag prints “It will remain on until the lid is opened or cancel is pressed.” Nothing else is printed, so schedule a visit if it repeats.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
Cycle Complete Light On will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Record Cycle Complete Light On character by character and note the product type: top-load washer.

Maytag prints no reset for Cycle Complete Light On, so record what the washer does rather than guessing a fix.

Note the model and the moment Cycle Complete Light On showed up; both help us plan.

Look for clothing or a hose edge stuck where the door or lid meets the cabinet.
Write down the model and serial numbers and the exact Cycle Complete Light On wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Maytag's top-load washer page gives Cycle Complete Light On a single line: “It will remain on until the lid is opened or cancel is pressed.” It adds nothing about cause.
Read the supporting manualMaytag's page for Cycle Complete Light On gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualAdd Garment Light On is a separate entry from Cycle Complete Light On on the top-load washer page, with its own wording.
Read the supporting manualDo not bypass or tape a door switch on the top-load washer. If Cycle Complete Light On keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-04-15; PH 13141 / PH 13141 (top-load washer)
Facts for Cycle Complete Light On are from the top-load washer table (PH 13141) of Maytag Product Help, checked November 2026; no model list is printed.
The top-load washer page reads “It will remain on until the lid is opened or cancel is pressed.” It prints nothing more about cause.
The page prints none. Write down what you see and schedule a visit if Cycle Complete Light On keeps appearing.
Nothing about replacing parts is printed for Cycle Complete Light On.
Model and serial numbers plus a note of what happened when Cycle Complete Light On appeared.
Maytag codes, symptoms, parts and service
For a top-load washer showing Add Garment Light On, Maytag prints “When Add Garment is lit, you may pause the cycle, open the lid, and add items.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.