What it means
Maytag's front-load washer page words rL like this: “This error code indicates that items were detected in the washer during the Clean Washer cycle.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Maytag washer rL / Display and signals
Maytag's front-load washer page words rL like this: “This error code indicates that items were detected in the washer during the Clean Washer cycle.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Also printed as rL
Maytag's front-load washer page words rL like this: “This error code indicates that items were detected in the washer during the Clean Washer cycle.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
rL repeats after the reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Check that your appliance is a front-load washer and copy rL exactly as the display shows it.

Wait five minutes without power before you check for rL again.

Run the washer briefly after the reset and see whether rL comes back.

Check your model manual for what rL means before treating it as a breakdown.
Note the model and the moment rL showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
rL is covered by this wording on the front-load washer page: “This error code indicates that items were detected in the washer during the Clean Washer cycle.”
Read the supporting manualCut power to the washer for five minutes at the breaker or by cycling power as the page says, then restore it and see whether rL comes back.
Read the supporting manualSUD is a separate entry from rL on the front-load washer page, with its own wording.
Read the supporting manualUse the front-load washer if it behaves normally; stop if there are odd noises, smells or heat. If rL keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-06-04; PH 14587 / PH 14587 (front-load washer)
Scope for rL: Maytag front-load washer, PH 14587, checked November 2026. Maytag lists no models on the rL page.
The front-load washer page reads “This error code indicates that items were detected in the washer during the Clean Washer cycle.” It prints nothing more about cause.
Yes, run it as printed and schedule a visit if rL stays.
Nothing about replacing parts is printed for rL.
Model and serial numbers plus a note of what happened when rL appeared.
Maytag codes, symptoms, parts and service
Maytag's front-load washer page words SUD like this: “Sud or Sd is displayed:.” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.