What it means
On a front-load washer, the entry for F0E1 says “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.” No reset is printed for it, so schedule a visit if it keeps appearing.
Maytag washer F0E1 / Display and signals
On a front-load washer, the entry for F0E1 says “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.” No reset is printed for it, so schedule a visit if it keeps appearing.
Also printed as F0E1
On a front-load washer, the entry for F0E1 says “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.” No reset is printed for it, so schedule a visit if it keeps appearing.
Power and water off before any panel comes off; towels down for spills.
F0E1 repeats after the reset.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Match the label on your appliance to the front-load washer list before you rely on the wording for F0E1.

No reset is printed here; note the behavior of the washer around F0E1 instead.

Note the model and the moment F0E1 showed up; both help us plan.

Open the front-load washer and spread the load evenly; very small or very heavy loads can unbalance a spin.
Write down the model and serial numbers and the exact F0E1 wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for F0E1 on a front-load washer: “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.”
Read the supporting manualMaytag's page for F0E1 gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualF20 is a neighbor of F0E1, not a synonym. The reset may overlap; the text does not.
Read the supporting manualDo not wedge or hold the drum while it spins. Never open a panel on the front-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-11-19; PH 14590 / PH 14590 (front-load washer)
F0E1 comes from Maytag Product Help (PH 14590) for the front-load washer, read in November 2026; the F0E1 entry names no models.
The help page states “The 'Clean Washer' cycle has been started, but the machine is detecting a load inside the washer.” Nothing else is added.
Nothing is printed for it, so record the display and schedule us if F0E1 continues.
No part is named for F0E1; the page gives only the wording above.
The model number, what F0E1 looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
Maytag's front-load washer page words F20 like this: “F20 indicates a water inlet problem-no water or insufficient water supply.” Try the five-minute power-off reset, and schedule a visit if the code returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.