What it means
The Maytag page for F21 on a front-load washer states “F21 indicates a drain problem.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Maytag washer F21 / Water and drain
The Maytag page for F21 on a front-load washer states “F21 indicates a drain problem.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Also printed as F21
The Maytag page for F21 on a front-load washer states “F21 indicates a drain problem.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Power and water off before any panel comes off; towels down for spills.
F21 repeats after the reset.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Match the label on your appliance to the front-load washer list before you rely on the wording for F21.

Wait five minutes without power before you check for F21 again.

Give the washer a minute on screen after the reset; a returning F21 means schedule a visit.

Look at the pump filter, if your model has an access panel, with the front-load washer off and the floor protected.
Keep the model number close and note when F21 appeared and what the front-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The front-load washer entry for F21 reads “F21 indicates a drain problem.” That is the whole explanation Maytag prints.
Read the supporting manualLeave the washer off power for five full minutes, switch it back on, and check the display for F21.
Read the supporting manualThe front-load washer list prints F20 next to F21, but with a different line. Look up the one on your display.
Read the supporting manualDo not rerun cycles on the front-load washer while water is left inside; it can overflow. If F21 keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-11-19; PH 14599 / PH 14599 (front-load washer)
Facts for F21 are from the front-load washer table (PH 14599) of Maytag Product Help, checked November 2026; no model list is printed.
For F21 on this front-load washer, the help page states “F21 indicates a drain problem.” Nothing else is added.
It may. Cut power for the full five minutes, restore it and watch. If F21 returns, schedule a visit.
Nothing about replacing parts is printed for F21.
Tell us the model, the display wording and when F21 first showed up.
Maytag codes, symptoms, parts and service
Maytag's front-load washer page words F20 like this: “F20 indicates a water inlet problem-no water or insufficient water supply.” Try the five-minute power-off reset, and schedule a visit if the code returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.