Inside the appliance
Washer drain pump filter. In plain English.
Many Maytag front-load washers hide a drain pump filter behind the bottom dispenser drawer. Product Help says to clean it occasionally, because a clogged filter makes the washer drain poorly and can lead to F9E1. Catch the water with a flat container and a cloth first.

Where it fits.
Washer drain pump filter in the appliance
On many front-load models, behind the bottom dispenser drawer. Product Help says the access depends on the model, so check your owner manual.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Washer drain pump filter trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Unplug the washer
Cut power before you reach for any filter or hose.
- 2
Catch the water
Place a broad, flat container under the filter and drain the small black hose into it. Lay a cotton cloth beneath the filter.
- 3
Turn it out
Turn the filter counterclockwise, pull off lint by hand and rinse it.
- 4
Seat it again
Turn it clockwise as far as it goes, with the handle near vertical. Return the drawer and clip the hose.
Cleaning or replacement?
Leave internal testing to a technician.
Water still does not drain after the filter is clean.
The filter will not turn or the drawer will not seat.
F9E1 returns.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Washer drain pump filter advice. Read the manual for your own model.
- Cleaning the Drain Pump Filter - Product Help | Maytag
- F9 E1 - Front Load Washer - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
How frequently should I clean the drain pump filter?
Product Help says occasionally, with no set interval. Clean it sooner if the washer drains slowly.
Do all Maytag washers have one?
Product Help says the filter is behind the bottom dispenser drawer on some models only. Check the owner manual for yours.
Which way does the filter turn?
Counterclockwise to take it out, clockwise to put it back until it stops.
Will cleaning it clear F9E1?
It can help if the filter was clogged. If F9E1 returns, the hose and door seal are the next checks, then a technician.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag washer F9E1 error code
F9E1 reads differently by product type: the front-load washer page states its title reads Long Drain Time; the top-load washer page states its title reads Long Drain. Arrange a technician visit with us if it will not go away.
Maytag washer not draining
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Washer repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.


