Inside the appliance
Washer door seal (bellows). In plain English.
The door seal, or bellows, on a Maytag front-load washer can trap small items, dirt and pet hair, and then hold water. Product Help says to inspect and clean it monthly and to run the Clean Washer cycle monthly. Its small drain holes can clog and slow draining.

Where it fits.
Washer door seal (bellows) in the appliance
The rubber ring between the door opening and the drum. Pull the seal gently back to see underneath.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Washer door seal (bellows) trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Empty the drum
Open the door and remove clothes or items.
- 2
Inspect the folds
Gently pull the seal back and look for stains, soil or objects underneath.
- 3
Wipe it down
Product Help gives a diluted bleach cleaner: 3/4 cup liquid chlorine bleach in 1 gallon warm water, wiped on and left for 5 minutes.
- 4
Run Clean Washer
Run the Clean Washer cycle monthly, per the page.
Cleaning or replacement?
Leave internal testing to a technician.
Water stays in the bellows after a cycle.
The seal has a tear or bulge.
Items keep ending up behind the seal and it drains slowly.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Washer door seal (bellows) advice. Read the manual for your own model.
- Cleaning the Door Seal - Front Load Washer - Product Help | Maytag
- Water Remains in Door Seal (Bellows) - Front Load Washer - Product Help | Maytag
- F9 E1 - Front Load Washer - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
How frequently should the door seal be cleaned?
Product Help says to inspect and clean it monthly and to run the Clean Washer cycle monthly.
Why does water sit in the seal?
Small items, dirt and pet hair collect in the bellows, and the buildup holds water.
Can the seal cause F9E1?
Yes. Product Help lists clogged drain holes inside the door seal among the reasons for poor draining.
Do I mix bleach with other cleaners?
No. Use only the diluted chlorine bleach mix the page gives and follow the label. Never combine it with other cleaners.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag washer F9E1 error code
F9E1 reads differently by product type: the front-load washer page states its title reads Long Drain Time; the top-load washer page states its title reads Long Drain. Arrange a technician visit with us if it will not go away.
Maytag washer not draining
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Washer repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.


