What it means
On a front-load washer, the entry for CL Code says “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Maytag washer CL Code / Display and signals
On a front-load washer, the entry for CL Code says “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Also printed as CL Code
On a front-load washer, the entry for CL Code says “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Power and water off before any panel comes off; towels down for spills.
CL Code repeats after the reset.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Check that your appliance is a front-load washer and copy CL Code exactly as the display shows it.

Maytag prints no reset for CL Code, so record what the washer does rather than guessing a fix.

Note the model and the moment CL Code showed up; both help us plan.

Note when CL Code appears: at start, mid-cycle or after a power cut.
Keep the model number close and note when CL Code appeared and what the front-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
CL Code is covered by this wording on the front-load washer page: “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.”
Read the supporting manualMaytag's page for CL Code gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualThe front-load washer list prints 1h, 2h, 3h....up to 12h next to CL Code, but with a different line. Look up the one on your display.
Read the supporting manualWhen in doubt, switch the front-load washer off. If CL Code keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-06-04; PH 14579 / PH 14579 (front-load washer)
Facts for CL Code are from the front-load washer table (PH 14579) of Maytag Product Help, checked November 2026; no model list is printed.
The front-load washer page reads “The CL code is a reminder to run the Clean Washer cycle and will appear after 30 cycles.” It prints nothing more about cause.
There is no reset on that page. Note what happens and book us if CL Code persists.
Not by itself; the page stops at the line it prints.
Tell us the model, the display wording and when CL Code first showed up.
Maytag codes, symptoms, parts and service
On a front-load washer, the entry for 1h, 2h, 3h....up to 12h says “When the display shows a number up to 12, followed by an 'h,' the Delay Wash has been activated.” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.