What it means
FH on a Maytag front-load washer is explained as “FH indicates that there is a water inlet problem, which is no or insufficient water supply.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Maytag washer FH / Water and drain
FH on a Maytag front-load washer is explained as “FH indicates that there is a water inlet problem, which is no or insufficient water supply.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Also printed as FH
FH on a Maytag front-load washer is explained as “FH indicates that there is a water inlet problem, which is no or insufficient water supply.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
FH repeats after the reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Record FH character by character and note the product type: front-load washer.

Maytag prints no reset for FH, so record what the washer does rather than guessing a fix.

Note the model and the moment FH showed up; both help us plan.

Look for water on the floor around the front-load washer before you restart a cycle.
Keep the model number close and note when FH appeared and what the front-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
FH is covered by this wording on the front-load washer page: “FH indicates that there is a water inlet problem, which is no or insufficient water supply.”
Read the supporting manualNo reset is printed for FH on the front-load washer page. Writing down what the washer does around the code is the useful thing to do.
Read the supporting manualFCE0 is a neighbor of FH, not a synonym. The reset may overlap; the text does not.
Read the supporting manualA fill problem will not harm you, but do not leave the front-load washer filling unattended.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-11-19; PH 14631 / PH 14631 (front-load washer)
Scope for FH: Maytag front-load washer, PH 14631, checked November 2026. Maytag lists no models on the FH page.
On a front-load washer showing FH, the help page states “FH indicates that there is a water inlet problem, which is no or insufficient water supply.” Nothing else is added.
There is no reset on that page. Note what happens and book us if FH persists.
Nothing about replacing parts is printed for FH.
Tell us the model, the display wording and when FH first showed up.
Maytag codes, symptoms, parts and service
Maytag’s front-load washer page for FCE0 (PH 14630) prints no meaning for the code, only a reset: cut power to the washer for five minutes, then restore it. Book a visit if FCE0 returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.