Using your appliance

The oven fan that keeps running after use

A fan still turning after a Maytag oven is switched off is usually the automatic cooling fan. Maytag says it runs during cooking and after the cycle ends, sometimes for extended periods, to cool the oven cavity and the electronic controls. Open the door: noise that stops is the convection fan, noise that continues is the cooling fan. [1][2]

A freestanding electric range with a lit clock display and a faint shimmer of warm air above the oven vent.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • The cooling fan runs during cooking and after the cycle completes. 12
  • It can run for extended periods depending on the internal and external temperatures. 12
  • Noise that stops when the door opens is the convection fan; noise that continues is the cooling fan. 1
  • A cooling fan speed message means the speed is too low or too high; try a one-minute breaker pause. 3
  • Gas ignitors tap every 1 to 3 minutes through a cycle, which is normal. 4

Is a lingering fan after shutdown a cause for concern?#

No. Maytag describes an automatic cooling fan that is meant to run while you cook and once the cycle has ended, sometimes for a long stretch, depending on the air temperature inside and outside the unit. A fan still turning after the last cycle is expected. 12

A Maytag range bakes for a household week after week, and the heat has to go somewhere afterward. The fan carries it out of the enclosed cavity so the controls are not left sitting in it. How long it runs says little by itself, so this guide spends its time on telling the two fans apart and on the single message that does point at the fan.

Fan or soundWhen you hear itWhat Maytag says
Cooling fanWhile cooking and after the cycle endsNormal, may run for extended periods 12
Convection fanPreheat and convection cyclesNormal, stops when the door swings open 1
Cooling fan speed messageAppears on the displaySpeed too low or too high, so pause the breaker 3
Ignitor clicking (gas)During a cycleNormal, a tap every minute or three 4
A hand rests flat on the closed glass door of a stainless freestanding range in a kitchen.
A fan heard once the cycle is over is usually the cooling fan. 12

How can I tell the cooling fan from the convection fan?#

Swing the oven door open. If the noise drops away, you were listening to the convection fan; if it keeps going, it is the cooling fan. Maytag prints this door test on its convection fan page. 1

  1. 1

    Let the noise settle#

    Stand by the range at a quiet moment, door shut, and listen for the fan. 1

  2. 2

    Open the door#

    Pull it open a comfortable distance. A convection fan stops when the door opens. 1

  3. 3

    Listen again#

    Silence means the convection fan. A sound that carries on means the cooling fan. 1

  4. 4

    Shut the door#

    A cooling fan that keeps turning is doing its job, so leave it to finish. 12

The page for a range without convection is shorter. It names only the automatic cooling fan, says it runs during cooking and afterward, and repeats that long runs are normal. 2 Our page on oven noise covers the other sounds an oven can make.

When does the convection fan switch on?#

During preheat, whichever function you chose, convection or not. It shuts off as soon as the door is opened. On electric convection models it starts the moment preheat begins or a convection cycle is selected. 1

That is why some ovens seem to blow air before any food goes in. Maytag lists this as ordinary behavior for the convection fan, not a symptom. 1 If the sound changes at the instant you open the door, you have found it.

What is the cooling fan protecting?#

The oven cavity and the electronic controls. Maytag says the fan keeps them cool during bake, broil and clean functions and for a while after the cycle, and that the run may be longer when the surrounding air is warm. 12

In short, it is the reason the control panel stays usable while the cavity is hot. A long clean cycle or a hot kitchen means a longer run. The pages set no time limit, so do not invent one. If a fan is still running long after the oven has been cold for hours, mention that on a call, since it falls outside what the pages call normal.

What does a cooling fan speed message mean?#

The control found the fan turning too slowly or too quickly. Maytag's page lists an airflow restriction, the oven cooling fan or its wiring as possible causes, and asks for a one-minute pause at the breaker followed by a minute of watching the display. 3

This is the only message in this guide that points at the fan itself. Cut the breaker for a minute, restore it, and check whether the message reappears while you confirm the oven runs. 3 The page does not ask you to hunt for the restriction yourself, and we do not either: the fan and its wiring sit behind panels that stay closed at home. If the message comes back, book a visit. The library of oven messages lists the page.

Do convection and non-convection ranges differ?#

Only by the extra fan. Both kinds carry the automatic cooling fan. A convection range adds the convection fan, which blows during preheat and stops when the door is opened. 12

Maytag's page for ranges without convection names the cooling fan alone and repeats that long runs are normal, while the convection page is the one with the door test. 12 On a convection model, a second fan sound during preheat is expected. On a model without convection, any fan you hear is the cooling fan. If you are unsure which kind you own, the manual says.

Is clicking from the oven part of the same story?#

On a gas oven, yes. The ignitors click until the flame is detected, and Maytag compares the short, sharp taps to a nail tapped on glass. Hearing them every 1 to 3 minutes through a cycle is normal. 4

That is a different noise from a fan hum. If clicking never stops, or carries on once a flame is lit, describe it carefully on a call, because the page covers only the ordinary rhythm. 4

What is worth writing down about the sound?#

Describe the sound and when it happens. A short recording made beside the range, with the door shut and then open, answers the first question we would ask.

  • Does the noise stop when the door swings open?
  • Does the fan run only after a cycle, or also after hours of rest?
  • Is there a cooling fan speed message on the display?
  • Is the sound a hum, a rattle, a whine or a click?

Ranges and built-in ovens are covered on our range page and our oven page. The other words an oven display can show are explained in the guide to display messages that are not errors.

Sources#

  1. Fan Noise - Convection - Range - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-06-02; PH 13640 · article text, Possible Solutions
  2. Fan Noise - Non Convection - Range - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-06-02; PH 13641 · article text, Possible Solutions
  3. Cooling Fan Speed - Range - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2024-11-07; PH 13889 · article text, Possible Solutions
  4. Click or Clicking Noise in Oven - Range - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2024-12-16; PH 13876 · article text, Possible Solutions

Here to help

Good questions.
Clear answers.

Talk to our team
Why is my range still blowing air after I turned it off?

Yes. Maytag says the automatic cooling fan runs during cooking and after the cycle completes, and that it can keep going for extended periods depending on the temperatures inside and outside the oven. [1][2]

How can I tell the cooling fan from the convection fan?

Open the oven door. If the noise stops, you heard the convection fan. If it carries on, it was the cooling fan. Maytag gives this door test on its convection fan page. [1]

What is the cooling fan doing?

It helps cool the enclosed oven cavity and the electronic controls during cooking and after the cycle completes, including bake, broil and clean functions. [1][2]

What does a cooling fan speed message mean?

Maytag's page says the fan speed is too low or too high, and the cause may be an airflow restriction, the oven cooling fan or its wiring. The page asks for a one-minute breaker pause and a check that the message stays off. [3]

Is a clicking sound from the oven a problem?

On a gas oven it is expected. Maytag says the ignitors click several times until a flame is detected, like a nail tapped on glass, and that hearing them every 1 to 3 minutes through a cycle is normal. [4]

Let’s take care of it.

A full hamper waits for no one.
Book the repair.