Using your appliance

The detergent drawer on a Maytag front-load washer

A Maytag front-load washer may use a detergent cartridge or a bulk dispenser. dET means the cartridge was not detected, so reseat it and close the drawer fully. A yellow light means a few cycles are left and red means empty. Detergent Low means the bulk dispenser needs more HE liquid. Clean the drawer parts under running water. [1][2][3][4]

A hand lifts a small blue-filled detergent cartridge from a pulled-out washer drawer, a detergent bottle and basket nearby.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • dET: cartridge not detected; reseat it and close the drawer fully, or ignore it if you use single-load doses. 1
  • Yellow level light: a few more cycles; red: empty. 3
  • Detergent Low flashes when the bulk dispenser needs more HE liquid detergent. 2
  • Packets and powder go in the washer basket, never in the dispenser. 2
  • Clean the drawer by hand and leave it cracked open to dry. 4

Which dispenser does this washer have?#

Maytag's front-load pages describe two setups: a removable detergent cartridge with a level light, and a bulk dispenser that flashes Detergent Low when it needs more. The names used on the pages are Optimal Dispense, Load & Go and bulk dispenser, so look at your drawer to see which applies. 123

A Maytag front-load washer is made for heavy weekly laundry, and the dispenser does the measuring so the load gets the right amount of detergent. That only works when the drawer is shut properly, the detergent is the right type and the parts are clean.

What you seeSetupWhat Maytag says
dET on the displayCartridgeThe cartridge is not detected 1
Yellow lightCartridgeEnough for only a few more cycles 3
Red lightCartridgeNo detergent in the cartridge 3
Detergent Low flashingBulk dispenserMore detergent is needed 2
The detergent drawer of a front-load washer pulled halfway out, a small removable cartridge visible inside.
Look at the drawer first to see whether a cartridge or a bulk reservoir sits inside. 12

What does dET mean?#

The washer does not detect the detergent dispenser cartridge. Maytag says to make sure the cartridge is inserted correctly and that the drawer closes completely. If you only ever use single-load doses of detergent, the page says to ignore the message. 1

The page names two checks: the cartridge's seating and the drawer's closing. Pull the drawer out, push the cartridge fully home, and slide the drawer back until it stops. The manual that came with the washer describes the Optimal Dispense cartridge in more detail. 1 Our dET page has the entry.

  1. 1

    Open the drawer#

    Pull it out and look at how the cartridge sits. 1

  2. 2

    Seat the cartridge#

    Push it all the way into its place so it is level in the drawer. 1

  3. 3

    Close the drawer completely#

    Slide it back until it stops before you start the cycle. 1

  4. 4

    Run a short cycle#

    See whether dET stays off. If you use single-load doses, the page says the message can be ignored. 1

What do the yellow and red detergent lights mean?#

Yellow means the cartridge holds enough detergent for only a few more cycles. Red means the cartridge is empty. Some models also have a Load & Go light just above these, and it lights only when the washer is switched on, the drawer is shut and the cartridge sits in place. 3

If the cartridge is removed and the drawer is shut, the Load & Go light stays dark. 3 That is a handy check: no light with the cartridge in and the drawer closed points back to seating, which is the dET check again. The Detergent Level Indicator entry has the text.

What is Detergent Low telling me?#

The bulk dispenser needs more detergent. Maytag says Detergent Low flashes on the display when it is time to add to the bulk dispenser. Fill it with high-efficiency liquid detergent only. 2

The page lists reminders. Do use only HE liquid and set the concentration level correctly. Do not place single-dose laundry packets or powder in the dispenser; put those straight into the washer basket. Do not use single-dose detergent and the bulk dispenser at the same time, because that can cause oversudsing and poor cleaning. 2 See the Detergent Low entry.

Why does the type of detergent matter so much?#

Because suds take over. Maytag says to use only HE detergent. Regular detergent or more than the recommended amount can cause excessive suds, and those can lead to the washer leaking, draining concerns and poor rinsing. 2

That is the link to the two problems people call us about. If a washer has been over-sudsed, you may see a leak or slow draining that the dispenser caused. Our leaking washer page and washer not draining page cover those, and the dispenser glossary entry explains the part.

How do I clean the dispenser drawer?#

Press the Dispenser Release Lever to unlock the drawer and take it out. Remove the inserts, wash all parts under running water, wipe the housing with mild soap and water, refit the inserts and slide the drawer back in. Do not put the parts in a dishwasher. 4

  1. 1

    Release the drawer#

    Press the Dispenser Release Lever and pull the drawer out. 4

  2. 2

    Take out the inserts#

    They are the detergent selector and the covers of the softener and bleach compartments. 4

  3. 3

    Rinse the parts#

    Wash them under running water. A small soft brush helps inside the dispenser. Never use a dishwasher. 4

    Two hands rinse the removable white inserts of a detergent drawer under a running tap in a laundry sink.
  4. 4

    Wipe the housing#

    Use mild soap and water on a soft cloth or sponge. 4

  5. 5

    Refit and close#

    Put the inserts back and slide the drawer in. 4

Should I leave the drawer open?#

Slightly, yes. After use, Maytag says to leave the drawer cracked open so it dries completely and less residue builds up in the drawer and housing. 4

Look at the drawer from time to time. Residue is what the page says builds up when the drawer stays damp. Our front-load washer water guide explains how much dampness in the dispenser area Maytag treats as normal.

Which message goes with which fix?#

Maytag's pages sort the messages neatly, so a short reference is easy to keep near the washer:

  • dET: seat the cartridge, close the drawer fully, or ignore it if you use single-load doses. 1
  • Yellow level light: a few cycles left in the cartridge. 3
  • Red level light: the cartridge is empty. 3
  • Detergent Low: add HE liquid to the bulk dispenser. 2
  • Suds, leaks or slow draining after a wash: check the detergent type and amount first. 2
  • Residue in the drawer: wash the parts and leave the drawer cracked open. 4

Why do the pages use two names for the cartridge?#

The dET page speaks of the Optimal Dispense cartridge, while the level-indicator page speaks of the Load & Go dispenser and cartridge. Maytag's pages do not say which model has which name, so match what you see in the drawer and keep the manual that came with the washer close. 13

The practical difference for you is small. Either way, a cartridge sits in the drawer, a light or message tells you its level, and the drawer must close fully for the washer to see it. A washer with a bulk dispenser works differently, since the display itself prompts you to refill it. 2

What should the visit notes say about the drawer?#

Say whether your washer has a cartridge or a bulk dispenser, what the display and the lights showed, and which detergent you used.

  • What did the display show: dET, Detergent Low or nothing?
  • Which color was the level light, if any?
  • Which detergent and form went into the washer?
  • When was the drawer last removed and cleaned?

Front-load and top-load washers are covered on our washer page.

Sources#

  1. dET - Front Load Washer - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-06-04; PH 14581 · article text, Possible Solutions
  2. Detergent Low - Front Load Washer - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-06-04; PH 14580 · article text, Possible Solutions
  3. Detergent Level Indicator Light - Front Load Washer - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2024-03-26; PH 7126 · article text, Possible Solutions
  4. Cleaning the Dispenser Drawer - Front Load Washer - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-06-04; PH 6930 · article text, Recommendations

Here to help

Good questions.
Clear answers.

Talk to our team
What does dET mean on a front-load washer?

Maytag says the washer does not detect its detergent dispenser cartridge. Seat the cartridge properly and make sure the drawer shuts all the way. If you use single-load doses of detergent, the page says to ignore the message. [1]

What do the yellow and red detergent lights mean?

On models with the indicator, yellow means the cartridge holds enough for only a few more cycles. Red means the cartridge is empty. The light only shows with the washer on, the drawer closed and the cartridge in place. [3]

Can I put powder or a detergent pod in the bulk dispenser?

No. Maytag's page says to use only high-efficiency liquid detergent in the bulk dispenser and to put single-dose packets or powder straight into the washer basket instead. [2]

Can I put the dispenser drawer parts in the dishwasher?

No. Maytag says not to clean the drawer parts in a dishwasher. Wash them under running water, and wipe the housing with mild soap and water on a soft cloth, a sponge or a small soft brush. [4]

Why leave the drawer open a little after a wash?

Maytag says a drawer left slightly open dries completely and builds up less residue in the drawer and housing area. [4]

Let’s take care of it.

A full hamper waits for no one.
Book the repair.