What it means
On a front-load washer, dET means the detergent dispenser cartridge is not detected. If you use single-load doses of detergent, you can ignore the message. Otherwise seat the cartridge fully and close the drawer completely.
Maytag washer dET / Water and drain
On a front-load washer, dET means the detergent dispenser cartridge is not detected. If you use single-load doses of detergent, you can ignore the message. Otherwise seat the cartridge fully and close the drawer completely.
Also printed as dET
On a front-load washer, dET means the detergent dispenser cartridge is not detected. If you use single-load doses of detergent, you can ignore the message. Otherwise seat the cartridge fully and close the drawer completely.
Maytag says to ignore the message if you are using single-load doses of detergent in the powdered compartment.
dET shows with the cartridge fully seated and the drawer completely closed.
Your Maytag to-do list, saved here on this device

Maytag says to ignore the message if you are using single-load doses of detergent in the powdered compartment.

Pull the dispenser drawer out and look at the cartridge in compartment A. [2]

The manual says to insert the cartridge completely in the detergent compartment and slide the drawer in until it is completely closed. The washer detects the cartridge once you start the washer. [2]

Product Help says the drawer must shut completely.

The cartridge takes liquid HE detergent only; do not put liquid in the single-load powdered compartment. [2]
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.

Component reference
F8E2 on a Maytag front-load washer is a dispenser system problem, and Product Help wants you to confirm the drawer or cartridge is not clogged with detergent.
Read the definitionMaytag prints that this error code indicates the detergent dispenser cartridge is not detected.
Read the supporting manualThe page says that if you use single-load doses of detergent, you should ignore the message. The manual lists a powdered HE compartment for a single load beside the cartridge compartment.
Read the supporting manualEach cartridge holds up to 18.5 oz (550 ml) of liquid HE detergent, fits into compartment B of the drawer, and is detected when you start the washer.
Read the supporting manualProduct Help points you to your owner’s manual for the Optimal Dispense cartridge. If dET stays with the cartridge seated and the drawer shut, book a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-06-04; PH 14581 / PH 14581 (front-load washer)
Manufacturer document
Maytag / Whirlpool Corporation (retailer copy of the Use & Care Guide, pdf.lowes.com)
W10254443A; PDF page numbers; retailer copy / PDF pp. 4, 5 and 11, Optimal Dispense drawer
The Product Help pages list no models, so the text applies to the washer type, not to a named model. Sources: Product Help PH 14581 and the retailer copy of the front-load washer Use & Care Guide W10254443A, pages 5 and 11.
It is a notice. Maytag says single-dose users can ignore it.
Slide it all the way into the compartment, then close the drawer completely.
The manual says use only HE detergent in this washer.
Maytag does not say.
Pull the tab, lift the fill door, fill to the MAX line with HE liquid detergent and close the door.
Maytag codes, symptoms, parts and service
F9E1 reads differently by product type: the front-load washer page states its title reads Long Drain Time; the top-load washer page states its title reads Long Drain. Arrange a technician visit with us if it will not go away.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
F8E2 on a Maytag front-load washer is a dispenser system problem, and Product Help wants you to confirm the drawer or cartridge is not clogged with detergent. On top-load models F8E2 is the bulk dispenser and F3E5 the mini dispenser. dET means the cartridge is not detected.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.