What it means
The Maytag page for Sud on a top-load washer states “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.” Nothing else is printed, so schedule a visit if it repeats.
Maytag washer Sud / Water and drain
The Maytag page for Sud on a top-load washer states “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.” Nothing else is printed, so schedule a visit if it repeats.
Also printed as Sud
The Maytag page for Sud on a top-load washer states “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.” Nothing else is printed, so schedule a visit if it repeats.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
Sud will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Check that your appliance is a top-load washer and copy Sud exactly as the display shows it.

Maytag prints no reset for Sud, so record what the washer does rather than guessing a fix.

Note the model and the moment Sud showed up; both help us plan.

Open the top-load washer and spread the load evenly; very small or very heavy loads can unbalance a spin.
Note the model and the moment Sud showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Sud is covered by this wording on the top-load washer page: “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.”
Read the supporting manualMaytag's page for Sud gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualThe top-load washer list prints Sd next to Sud, but with a different line. Look up the one on your display.
Read the supporting manualAn unbalanced load is usually a loading matter; the top-load washer is safe to use once the load is redistributed. Never open a panel on the top-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-06-04; PH 13161 / PH 13161 (top-load washer)
Sud comes from Maytag Product Help (PH 13161) for the top-load washer, read in November 2026; the Sud entry names no models.
For Sud on this top-load washer, the help page states “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.” Nothing else is added.
Nothing is printed for it, so record the display and schedule us if Sud continues.
Maytag names no part here. Read the message and follow the steps.
The model and serial numbers, the exact display for Sud, and what the top-load washer was doing at the time.
Maytag codes, symptoms, parts and service
On a top-load washer, the entry for Sd says “If Sd or Sud (excess suds) appears in the display, you have excessive suds in the washer.” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.