What it means
Lid on a Maytag top-load washer is explained as “Is the lid open?” Nothing else is printed, so schedule a visit if it repeats.
Maytag washer Lid / Door and lid
Lid on a Maytag top-load washer is explained as “Is the lid open?” Nothing else is printed, so schedule a visit if it repeats.
Also printed as Lid
Lid on a Maytag top-load washer is explained as “Is the lid open?” Nothing else is printed, so schedule a visit if it repeats.
Power and water off before any panel comes off; towels down for spills.
Lid returns, or the top-load washer behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Check that your appliance is a top-load washer and copy Lid exactly as the display shows it.

No reset is printed here; note the behavior of the washer around Lid instead.

Keep the model number close and note when Lid appeared and what the top-load washer was doing.

Look for clothing or a hose edge stuck where the door or lid meets the cabinet.
Keep the model number close and note when Lid appeared and what the top-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for Lid on a top-load washer: “Is the lid open?”
Read the supporting manualNo reset is printed for Lid on the top-load washer page. Writing down what the washer does around the code is the useful thing to do.
Read the supporting manualLd is a separate entry from Lid on the top-load washer page, with its own wording.
Read the supporting manualThe top-load washer will not run a cycle safely with the door or lid not locking, so wait for a visit if it keeps happening. If Lid keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-07-03; PH 13156 / PH 13156 (top-load washer)
Scope for Lid: Maytag top-load washer, PH 13156, checked November 2026. Maytag lists no models on the Lid page.
As long as Lid stays on the top-load washer, the help page states “Is the lid open?” Nothing else is added.
The page prints none. Write down what you see and schedule a visit if Lid keeps appearing.
Nothing about replacing parts is printed for Lid.
The model and serial numbers, the exact display for Lid, and what the top-load washer was doing at the time.
Maytag codes, symptoms, parts and service
On a top-load washer, the entry for Ld says “If Ld(drain pump system problem-long drain) appears in the display, the washer is taking too long to drain...” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.