What it means
Maytag's top-load washer page words dLO like this: “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.” No reset is printed for it, so schedule a visit if it keeps appearing.
Maytag washer dLO / Door and lid
Maytag's top-load washer page words dLO like this: “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.” No reset is printed for it, so schedule a visit if it keeps appearing.
Also printed as dLO
Maytag's top-load washer page words dLO like this: “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.” No reset is printed for it, so schedule a visit if it keeps appearing.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
dLO repeats after the reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Check that your appliance is a top-load washer and copy dLO exactly as the display shows it.

No reset is printed here; note the behavior of the washer around dLO instead.

Keep the model number close and note when dLO appeared and what the top-load washer was doing.

Do not force a locked door or lid; wait for the top-load washer to finish and release.
Keep the model number close and note when dLO appeared and what the top-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.

Component reference
On a Maytag front-load washer, F5E3 means the door is not locking properly and F22 is a front door lock issue.
Read the definitiondLO is covered by this wording on the top-load washer page: “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.”
Read the supporting manualNo reset is printed for dLO on the top-load washer page. Writing down what the washer does around the code is the useful thing to do.
Read the supporting manualSUD is a neighbor of dLO, not a synonym. The reset may overlap; the text does not.
Read the supporting manualDo not bypass or tape a door switch on the top-load washer. Never open a panel on the top-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-07-03; PH 13147 / PH 13147 (top-load washer)
dLO comes from Maytag Product Help (PH 13147) for the top-load washer, read in November 2026; the dLO entry names no models.
The help page states “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.” Nothing else is added.
Nothing is printed for it, so record the display and schedule us if dLO continues.
No part is named for dLO; the page gives only the wording above.
Tell us the model, the display wording and when dLO first showed up.
Maytag codes, symptoms, parts and service
The Maytag page for Sud on a top-load washer states “If Sd or Sud (excess suds) appears in the display, you have excessive suds in washer.” Nothing else is printed, so schedule a visit if it repeats.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
On a Maytag front-load washer, F5E3 means the door is not locking properly and F22 is a front door lock issue. Product Help says to shut the door completely, clear anything from the latch, and wipe soap buildup off the lock. F5E1 names the door switch.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.