What it means
Maytag's top-load washer page words dU like this: “If dU (Lid cannot unlock) appears in display, the washer detects that there are objects on washer lid...” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Maytag washer dU / Door and lid
Maytag's top-load washer page words dU like this: “If dU (Lid cannot unlock) appears in display, the washer detects that there are objects on washer lid...” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Also printed as dU
Maytag's top-load washer page words dU like this: “If dU (Lid cannot unlock) appears in display, the washer detects that there are objects on washer lid...” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
dU will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Match the label on your appliance to the top-load washer list before you rely on the wording for dU.

No reset is printed here; note the behavior of the washer around dU instead.

Keep the model number close and note when dU appeared and what the top-load washer was doing.

Look at the outside vent flap while the top-load washer runs; air should push it open.
Write down the model and serial numbers and the exact dU wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.

Component reference
On a Maytag front-load washer, F5E3 means the door is not locking properly and F22 is a front door lock issue.
Read the definitiondU is covered by this wording on the top-load washer page: “If dU (Lid cannot unlock) appears in display, the washer detects that there are objects on washer lid preventing it from unlocking.”
Read the supporting manualMaytag's page for dU gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualdLO is a separate entry from dU on the top-load washer page, with its own wording.
Read the supporting manualIf the vent cannot be cleared yourself, leave the top-load washer off and book us. Never open a panel on the top-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-07-03; PH 13149 / PH 13149 (top-load washer)
Scope for dU: Maytag top-load washer, PH 13149, checked November 2026. Maytag lists no models on the dU page.
On the top-load washer page the line is “If dU (Lid cannot unlock) appears in display, the washer detects that there are objects on washer lid preventing it from unlocking.” No further cause is given.
No; Maytag gives dU no reset steps. If it repeats, schedule a visit.
No part is named for dU; the page gives only the wording above.
The model number, what dU looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
Maytag's top-load washer page words dLO like this: “If dL (lid lock will not lock or lid lock failure) appears in the display, the lid is not locking.” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
On a Maytag front-load washer, F5E3 means the door is not locking properly and F22 is a front door lock issue. Product Help says to shut the door completely, clear anything from the latch, and wipe soap buildup off the lock. F5E1 names the door switch.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.