What it means
Maytag words E61 as the oven sensor circuit reporting an open condition to the control board. The sensor, the appliance control board or the wiring may be the cause. Reset at the breaker for one minute and monitor for one minute.
Maytag microwave E61 / Sensors
Maytag words E61 as the oven sensor circuit reporting an open condition to the control board. The sensor, the appliance control board or the wiring may be the cause. Reset at the breaker for one minute and monitor for one minute.
Also printed as E61
Maytag words E61 as the oven sensor circuit reporting an open condition to the control board. The sensor, the appliance control board or the wiring may be the cause. Reset at the breaker for one minute and monitor for one minute.
Unplug the microwave or switch off its breaker before any panel comes off, and never open the casing, because it holds charge.
E61 returns after the one-minute breaker reset.
Your Maytag to-do list, saved here on this device

Cancel the cooking program.

Then back on.

Verify operation.

E61 is open. E62 and E63 are shorted. Record which one you see.
Do not open the microwave housing; sensors, boards and wiring sit behind high-voltage parts.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The oven sensor circuit reported an open condition to the control board. There may be a problem with the sensor, the appliance control board or the associated wiring.
Read the supporting manualBoth say the oven sensor circuit reported a shorted condition, with the same three possibilities and the same reset. E61 is the open one.
Read the supporting manualThe pages are identical in cause and remedy. Maytag does not print a difference.
Read the supporting manualNo. E21 and E22 are the thermal sensor codes; E61 to E63 name the oven sensor.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2021-04-29; PH 10337 / PH 10337 (over-the-range microwave)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2021-04-29; PH 10338 / PH 10338 (over-the-range microwave)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2021-04-29; PH 10339 / PH 10339 (over-the-range microwave)
Product Help lists no models for this entry; the page covers the over-the-range microwave tree. Source: Product Help PH 10337, with the E62 and E63 pages.
Maytag does not describe it on this page.
It is reported on any program that uses the sensor.
After the reset, yes. Stop if E61 returns.
Tell us both.
Maytag codes, symptoms, parts and service
Maytag prints E24 as the oven reaching an overheat condition of 500F (260C). The thermal sensor, gas sensor, appliance control board or wiring may be the cause. Let it cool, reset at the breaker for one minute, and book a visit if it returns.
If a Maytag microwave will not start, the display usually explains why: a door message, the LOC padlock icon, or Demo Mode. Reopen and reclose the door first, then check the lock and demo settings before you book a visit.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.