What it means
The Maytag page for F0E8 on a top-load washer states “F0E8 - Water remains in tub.” No reset is printed for it, so schedule a visit if it keeps appearing.
Maytag washer F0E8 / Water and drain
The Maytag page for F0E8 on a top-load washer states “F0E8 - Water remains in tub.” No reset is printed for it, so schedule a visit if it keeps appearing.
Also printed as F0E8
The Maytag page for F0E8 on a top-load washer states “F0E8 - Water remains in tub.” No reset is printed for it, so schedule a visit if it keeps appearing.
Power and water off before any panel comes off; towels down for spills.
F0E8 will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Record F0E8 character by character and note the product type: top-load washer.

No reset is printed here; note the behavior of the washer around F0E8 instead.

Write down the model and serial numbers and the exact F0E8 wording before you call.

Check both water taps behind the top-load washer are fully open and the hoses are not kinked.
Keep the model number close and note when F0E8 appeared and what the top-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
F0E8 is covered by this wording on the top-load washer page: “F0E8 - Water remains in tub.”
Read the supporting manualMaytag's page for F0E8 gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualThe top-load washer list prints F0E0 next to F0E8, but with a different line. Look up the one on your display.
Read the supporting manualIf water collects on the floor, shut the taps and switch the top-load washer off. If F0E8 keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-01-27; PH 13429 / PH 13429 (top-load washer)
Facts for F0E8 are from the top-load washer table (PH 13429) of Maytag Product Help, checked November 2026; no model list is printed.
The top-load washer page reads “F0E8 - Water remains in tub.” It prints nothing more about cause.
No; Maytag gives no reset steps for it. If it repeats, schedule a visit.
Maytag prints nothing about replacing parts here.
The model number, what the display showed, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
Maytag’s top-load washer page for F0E0 (PH 13423) prints no meaning for the code, only a reset: cut power to the washer for five minutes, then restore it. Book a visit if F0E0 returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.