What it means
F0E9 is an unbalanced load on a top-load washer. The washer first tries to self-correct by refilling and rotating gently; if it cannot, it shows the code. Cancel, drain, rearrange or reduce the load, then restart.
Maytag washer F0E9 / Information
F0E9 is an unbalanced load on a top-load washer. The washer first tries to self-correct by refilling and rotating gently; if it cannot, it shows the code. Cancel, drain, rearrange or reduce the load, then restart.
Also printed as F0E9
F0E9 is an unbalanced load on a top-load washer. The washer first tries to self-correct by refilling and rotating gently; if it cannot, it shows the code. Cancel, drain, rearrange or reduce the load, then restart.
Power and water off before any panel comes off; towels down for spills.
F0E9 repeats with a loose, balanced load on a level washer.
Your Maytag to-do list, saved here on this device

Press Start or disconnect the power cord to cancel.

Run a drain-only cycle.

Make sure the load is level and not overloaded. Try Bulky or Heavy Duty.

Rock it diagonally from corner to corner with your hands; if it rocks, level the feet.

Press Start to pause, open the lid, rearrange and press Start again.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The heading is “F0E9 - Unbalanced Load.” The article says off-balance loads create basket movement, noise, vibration, reduced spin speed and longer cycle times, and that the error typically occurs during the spin, after the wash portion.
Read the supporting manualIt refills and gently rotates back and forth to redistribute the clothing. If that fails it shows the error.
Read the supporting manualLoad in loose heaps no higher than the top row of holes, balance heavy with lighter items, use Bulky for oversized items, never wash a single absorbent article like one rug, and keep the washer level side to side and front to back.
Read the supporting manualF0E5 on the top-load tree says unbalanced or too large and links an unbalanced or overloaded article. F0E9 is the long how-to.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-07-01; PH 13430 / PH 13430 (top-load washer)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-07-01; PH 13427 / PH 13427 (top-load washer)
The Product Help pages list no models, so the text applies to the washer type, not to a named model. Sources: Product Help PH 13430 (top-load) and the top-load F0E5 page.
The article treats it as a load problem and gives rearranging steps.
Possibly, if the spin was reduced or stopped.
Rock the washer diagonally; if it moves, adjust the feet.
It cannot balance on its own; add two or three garments.
Maytag codes, symptoms, parts and service
The Maytag page for F0E8 on a top-load washer states “F0E8 - Water remains in tub.” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.