What it means
F4 E2 names the microwave sensor/thermistor, the microwave appliance manager, or the wiring. It is a combination wall oven entry; there is no range page. Do the one-minute breaker reset and tell us whether a microwave cycle starts.
Maytag oven F4E2 / Sensors
F4 E2 names the microwave sensor/thermistor, the microwave appliance manager, or the wiring. It is a combination wall oven entry; there is no range page. Do the one-minute breaker reset and tell us whether a microwave cycle starts.
Also printed as F4E2
F4 E2 names the microwave sensor/thermistor, the microwave appliance manager, or the wiring. It is a combination wall oven entry; there is no range page. Do the one-minute breaker reset and tell us whether a microwave cycle starts.
Power off at the breaker before any panel comes off; a gas smell means getting out and calling the gas utility from outside.
F4 E2 returns after the reset.
Your Maytag to-do list, saved here on this device

F4 E entries are the microwave side of a wall oven.

Breaker off for one minute, then on, and monitor the oven for one minute.

Note whether it starts, and what the display shows.

F4 E1 and F4 E4 also name the appliance manager.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
There may be a problem with the Microwave Sensor/Thermistor, the Microwave Appliance Manager, or the associated wiring.
Read the supporting manualF4 E1 lists a "Thermistor" and the "Appliance Manager" without the word microwave. F4 E2 spells it out.
Read the supporting manualF4 E4 pairs the microwave humidity sensor with the microwave appliance manager.
Read the supporting manualRun the reset once. If it comes back, book; the two named parts are tested on site.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14440 / PH 14440 (wall oven)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14439 / PH 14439 (wall oven)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14442 / PH 14442 (wall oven)
Wall oven page PH 14440, with PH 14439 and PH 14442 for neighbors.
Maytag does not define it. It is a temperature-sensing part.
No range page exists for it.
The page lists two parts and the wiring; it does not pick one.
The page does not say.
Maytag codes, symptoms, parts and service
F4E1 on a wall oven means Maytag suspects the thermistor, the appliance manager or the wiring. Begin with the reset; if the code is back afterward, book a technician.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.