What it means
F4E1 on a wall oven means Maytag suspects the thermistor, the appliance manager or the wiring. Begin with the reset; if the code is back afterward, book a technician.
Maytag oven F4E1 / Sensors
F4E1 on a wall oven means Maytag suspects the thermistor, the appliance manager or the wiring. Begin with the reset; if the code is back afterward, book a technician.
Also printed as F4E1
F4E1 on a wall oven means Maytag suspects the thermistor, the appliance manager or the wiring. Begin with the reset; if the code is back afterward, book a technician.
Turn the breaker off before you touch anything behind a panel.
F4E1 returns, or the wall oven behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Turn the breaker off before you touch anything behind a panel. If you smell gas, leave the house and call your gas utility from outside.

Record F4E1 character by character and note the product type: wall oven.

Cut power at the breaker for a minute, restore it, then check for F4E1.

Give the oven a minute on screen after the reset; a returning F4E1 means schedule a visit.

Watch whether the wall oven reaches and holds the temperature you set; a sensor problem often shows up as food that cooks too fast or too slowly.
Keep the model number close and note when F4E1 appeared and what the wall oven was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The wall oven list ties F4E1 to the thermistor, the appliance manager or the wiring. That is a set of candidates, and the page does not pick one.
Read the supporting manualMaytag's reset is a minute at the breaker: off, wait, on. Then leave the oven in view for another minute and note whether F4E1 returns.
Read the supporting manualF4E0 sits beside F4E1 on the wall oven page and names the microwave inverter or the wiring; the code names the thermistor, the appliance manager or the wiring.
Read the supporting manualA sensor that misreads can mean wrong temperatures, so check food with a thermometer while the wall oven is in use.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14439 / PH 14439 (wall oven)
Facts for F4E1 are from the wall oven table (PH 14439) of Maytag Product Help, checked November 2026; no model list is printed.
F4E1 is printed against the thermistor, the appliance manager or the wiring; the page does not narrow it down.
Yes, give it the whole minute. If F4E1 is still there afterward, schedule a visit.
Maytag names the thermistor, the appliance manager or the wiring. Which one failed is for a technician with a meter to decide.
The model number, what F4E1 looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
F4 E0 is a wall oven code for combination models. Maytag names the microwave inverter or the wiring, and publishes no range page for it. Switch the breaker off for one minute and back on, then book a visit if it returns.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.