What it means
Maytag's wall oven page links F4 to the oven cavity control or the wiring. It does not say which one, so run the reset below and schedule a visit if the code returns.
Maytag oven F4 / Control board
Maytag's wall oven page links F4 to the oven cavity control or the wiring. It does not say which one, so run the reset below and schedule a visit if the code returns.
Also printed as F4
Maytag's wall oven page links F4 to the oven cavity control or the wiring. It does not say which one, so run the reset below and schedule a visit if the code returns.
Power off at the breaker before any panel comes off; a gas smell means getting out and calling the gas utility from outside.
F4 returns, or the wall oven behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Power off at the breaker before any panel comes off; a gas smell means getting out and calling the gas utility from outside.

Match the label on your appliance to the wall oven list before you rely on the wording for F4.

Breaker off for one full minute, then back on, and look for F4.

Give the oven a minute on screen after the reset; a returning F4 means schedule a visit.

Ask yourself whether a power cut, storm or cleaning cycle came just before F4.
Write down the model and serial numbers and the exact F4 wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visit

A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The wall oven list ties F4 to the oven cavity control or the wiring. That is a set of candidates, and the page does not pick one.
Read the supporting manualMaytag's reset is a minute at the breaker: off, wait, on. Then leave the oven in view for another minute and note whether F4 returns.
Read the supporting manualRead the exact display: F3E9 means the lower oven temperature sensor, the control or the wiring on the wall oven page, and F4 means the oven cavity control or the wiring.
Read the supporting manualA control problem can stop heating or cause odd behavior, so stay near the wall oven while it runs. Never open a panel on the wall oven yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14437 / PH 14437 (wall oven)
Facts for F4 are from the wall oven table (PH 14437) of Maytag Product Help, checked November 2026; no model list is printed.
Maytag lists the oven cavity control or the wiring. It is a possible-cause list, not a confirmed failure.
It is the page's first step and costs nothing. A returning F4 afterward means schedule us.
No. the oven cavity control or the wiring are all candidates and the page gives no way to choose.
The model and serial numbers, the exact display for F4, and what the wall oven was doing at the time.
Maytag codes, symptoms, parts and service
F3E9 on a wall oven means Maytag suspects the lower oven temperature sensor, the control or the wiring. Begin with the reset; if the code is back afterward, book a technician.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.