On this page
- Add clothes loosely, only as high as the highest ring of holes in the basket wall. 1
- Keep the top of the impeller visible, and do not add extra water. 1
- Do not wash a single absorbent article; wash two or three together. 1
- oL: cancel, run a drain-only cycle, remove or rearrange items. 2
- OFb: once the lid unlocks, redistribute the load, lower the lid and tap Start/Pause. 3
How full can I load a Maytag top-load washer?#
Add clothes loosely and only as high as the highest ring of holes in the basket wall, with the top of the impeller visible. Maytag also says not to add more water to compensate, because the impeller needs to engage the clothes to clean them. 1
A top-load Maytag is one of the hardest-working machines in the house, and it forgives a lot. The place it does not forgive is the spin. When the basket reaches speed, any weight piled on one side swings the whole drum. The washer tries to cure it by refilling and rocking the basket back and forth, and if that fails it shows a message. 1
| Habit | What Maytag says | Better |
|---|---|---|
| Filling past the highest ring of holes | Load loosely, no higher than that row 1 | Split into two loads |
| Covering the impeller | Top of impeller should be visible 1 | Lift out some items |
| Adding extra water | Items float; cleaning action drops 1 | Leave the water level alone |
| Washing one rug or towel | Not recommended; wash two or three 1 | Add a few matching items |
| Dropping a quilt in a lump | Arrange in a doughnut shape 1 | Ring it around the impeller |

Why does an unbalanced load matter so much?#
Because the washer cannot spin it at full speed. Maytag says an off-balance load can cause noise, vibration, reduced spin speed, longer cycle times and poorer performance. The trouble usually shows up in the spin, after the wash portion has finished. 1
The signs the page lists are loud noises during spin, excessive shaking and clothes that remain wet when the cycle is done. Where the imbalance is large, the washer may stop spinning and wait for you to move the clothes yourself. 1 If you hear your washer thumping or walking, our shaking washer page goes through what we look at on a visit.
What goes wrong with heavy and bulky items?#
Quilts, cotton blankets and rugs soak up water and become heavy, so they often bring the imbalance. Check the care label first, since some bulky items are labeled for a commercial-style front-load washer only. 1
For items that absorb a lot of water, arrange them in a doughnut shape around the impeller. Do not wash one absorbent piece alone; two or three together spin better. Wash similar items together, and never overload. 1 For oversized, nonabsorbent items such as comforters or poly-filled jackets, the OFb page points to the Bulky/Sheets cycle with the Deep Water Wash option, and says other items are not right for that cycle with a normal choice. 3
- 1
- 2
- 3
- 4
What does oL ask me to do?#
oL means the load is too large. Cancel the cycle by pressing Start or unplugging the washer, run a drain-only cycle when water is sitting in the basket, then rearrange or remove items before a new cycle. Maytag suggests Bulky or Heavy Duty for the next run. 2
If the cycle can be paused instead, press Start to pause it, open the lid, rearrange the clothes or reduce the load, and press Start again. If the wash is already done and all that remains is getting the water out, a Drain & Spin cycle after rearranging will do it. 2 See the oL entry for the page text.
What does OFb ask me to do, and what about uL?#
OFb means the load is off balance and the washer could not correct it by itself. If OFb is flashing and the washer has stopped, let the lid unlock, spread the clothes evenly, lower the lid and tap Start/Pause. Maytag's uL page carries the same off-balance text. 34
The OFb pages add three tips. Wet items added mid-cycle, or more water in the basket, can throw the washer off balance. Avoid washing single items, and balance something like a rug or a jeans jacket with a few towels. Load items in loose heaps evenly around the washplate. 34 The cancel-and-drain sequence on the OFb page matches the oL one: cancel by pressing Start or unplugging, drain if there is water, rearrange, then use Bulky or Heavy Duty. 3 Our OFb page and the uL entry hold the details.
Could the floor or the feet be the problem?#
Yes. Maytag says the washer must be level with all four feet in firm contact with the floor. Rock it diagonally corner to corner with your hands. If it rocks, adjust the feet until it does not. An unlevel washer can unbalance loads and shake during spin. 1
If a drain pan sits under the washer, the leveling legs may need to be raised to suit the pan's height. 1 Many phones carry a level app, and the page points to using one on the top edge. This is the check we ask for first when a washer walks across the floor.

What is a quick loading checklist?#
Maytag's pages boil down to a handful of habits you can run through before pressing Start:
- Check the care label for bulky items. 1
- Load clothes loosely, no higher than the highest ring of holes. 1
- Keep the top of the impeller visible. 1
- Spread heavy or absorbent items in a ring around the impeller. 1
- Never wash a single absorbent piece alone. 1
- Leave the water level alone. 1
- Make sure all four feet hold firm on the floor. 1
What do I mention about the load?#
Describe the load and the symptom: what was in the washer, how high, whether OFb or oL showed, and when in the cycle the shaking began. A phone video of the spin is more useful than words.
- What items were in the load, and was a rug or quilt among them?
- How high was the load compared with the highest ring of holes?
- Did oL, OFb or uL show, and did a rebalance help?
- Did the rock test move the washer?
Both washer layouts are covered on our washer page.
Sources#
- Vibration or Out of Balance loads - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2026-05-19; PH 13183 · article text, Possible Solutions
- oL - Error Code - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-07-01; PH 13158 · article text, Possible Solutions
- OFb or ofb - Error Code - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2025-07-01; PH 13157 · article text, Possible Solutions
- uL - Error Code - Product Help | MaytagMaytag Product Help (producthelp.maytag.com) · dateModified 2024-07-03; PH 13162 · article text, Possible Solutions



