What it means
For a Maytag top-load washer, Maytag's page for OFb says the washer could not even out an off-balance load by itself and needs you to spread the load around the washplate. Arrange a technician visit with us if it will not go away.
Maytag washer OFb / Information
For a Maytag top-load washer, Maytag's page for OFb says the washer could not even out an off-balance load by itself and needs you to spread the load around the washplate. Arrange a technician visit with us if it will not go away.
Also printed as OFb
For a Maytag top-load washer, Maytag's page for OFb says the washer could not even out an off-balance load by itself and needs you to spread the load around the washplate. Arrange a technician visit with us if it will not go away.
Check the exact spelling of OFb on the display (capitals, spaces, dashes) along with the product type: top-load washer.
OFb keeps showing after you have run the checks above.
Your Maytag to-do list, saved here on this device

Check the exact spelling of OFb on the display (capitals, spaces, dashes) along with the product type: top-load washer.

Note when it appears and whether anything changes after you cancel the cycle or set the product down for a few minutes.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Maytag's page says the washer could not even out an off-balance load by itself and needs you to spread the load around the washplate.
Read the supporting manualNo reset interval is printed for it.
Read the supporting manualSchedule one with us if OFb keeps showing after you have run the checks above. Have the exact display wording and the model number ready.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-07-01; PH 13157 / PH 13157 (top-load washer)
Scope: Maytag top-load washer. Source pages: Maytag Product Help, PH 13157, checked November 2026.
Maytag's page says the washer could not even out an off-balance load by itself and needs you to spread the load around the washplate.
No reset interval is printed on the page. Note when the message appears, and schedule a visit if it will not clear.
No part is named on the page. It describes the condition and what you can do about it.
Schedule one if OFb keeps showing after you have run the checks above. Until then, the steps above are all the page asks of you.
Maytag codes, symptoms, parts and service
F9E1 reads differently by product type: the front-load washer page states its title reads Long Drain Time; the top-load washer page states its title reads Long Drain. Arrange a technician visit with us if it will not go away.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.