What it means
oL on a Maytag top-load washer is explained as “The load is too large if oL (overloaded) appears in the display.” Nothing else is printed, so schedule a visit if it repeats.
Maytag washer oL / Information
oL on a Maytag top-load washer is explained as “The load is too large if oL (overloaded) appears in the display.” Nothing else is printed, so schedule a visit if it repeats.
Also printed as oL
oL on a Maytag top-load washer is explained as “The load is too large if oL (overloaded) appears in the display.” Nothing else is printed, so schedule a visit if it repeats.
Power and water off before any panel comes off; towels down for spills.
oL returns, or the top-load washer behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Record oL character by character and note the product type: top-load washer.

No reset is printed here; note the behavior of the washer around oL instead.

Keep the model number close and note when oL appeared and what the top-load washer was doing.

Open the top-load washer and spread the load evenly; very small or very heavy loads can unbalance a spin.
Note the model and the moment oL showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The top-load washer entry for oL reads “The load is too large if oL (overloaded) appears in the display.” That is the whole explanation Maytag prints.
Read the supporting manualNo reset is printed for oL on the top-load washer page. Writing down what the washer does around the code is the useful thing to do.
Read the supporting manualdrn is a neighbor of oL, not a synonym. The reset may overlap; the text does not.
Read the supporting manualAn unbalanced load is usually a loading matter; the top-load washer is safe to use once the load is redistributed. Never open a panel on the top-load washer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-07-01; PH 13158 / PH 13158 (top-load washer)
Scope for oL: Maytag top-load washer, PH 13158, checked November 2026. Maytag lists no models on the oL page.
With oL on the top-load washer, Maytag's wording is “The load is too large if oL (overloaded) appears in the display.” That is the whole entry.
Nothing is printed for it, so record the display and schedule us if oL continues.
Not by itself; the page stops at the line it prints.
Tell us the model, the display wording and when oL first showed up.
Maytag codes, symptoms, parts and service
The Maytag page for drn on a top-load washer states “If F9 E1 (drain pump system problem-long drain) appears in the display, the washer is taking too long to...” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.