What it means
Maytag's top-load washer page words uL like this: “The washer could not remedy the off-balance load via automated methods and now needs manual intervention to...” No reset is printed for it, so schedule a visit if it keeps appearing.
Maytag washer uL / Information
Maytag's top-load washer page words uL like this: “The washer could not remedy the off-balance load via automated methods and now needs manual intervention to...” No reset is printed for it, so schedule a visit if it keeps appearing.
Also printed as uL
Maytag's top-load washer page words uL like this: “The washer could not remedy the off-balance load via automated methods and now needs manual intervention to...” No reset is printed for it, so schedule a visit if it keeps appearing.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
uL will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Record uL character by character and note the product type: top-load washer.

Maytag prints no reset for uL, so record what the washer does rather than guessing a fix.

Keep the model number close and note when uL appeared and what the top-load washer was doing.

Clean the lint screen on the top-load washer, then look at the vent hose behind it for kinks or crushing.
Note the model and the moment uL showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
uL is covered by this wording on the top-load washer page: “The washer could not remedy the off-balance load via automated methods and now needs manual intervention to redistribute the load evenly around the...”
Read the supporting manualMaytag's page for uL gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the washer shows.
Read the supporting manualThe top-load washer list prints oL next to uL, but with a different line. Look up the one on your display.
Read the supporting manualIf the vent cannot be cleared yourself, leave the top-load washer off and book us.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-07-03; PH 13162 / PH 13162 (top-load washer)
Facts for uL are from the top-load washer table (PH 13162) of Maytag Product Help, checked November 2026; no model list is printed.
When uL is on the display of a top-load washer, the help page states “The washer could not remedy the off-balance load via automated methods and now needs manual intervention to redistribute the load evenly around the...” Nothing else is added.
Nothing is printed for it, so record the display and schedule us if uL continues.
Not by itself; the page stops at the line it prints.
The model number, what uL looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
oL on a Maytag top-load washer is explained as “The load is too large if oL (overloaded) appears in the display.” Nothing else is printed, so schedule a visit if it repeats.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.