What it means
F0E7 means clothing was detected while the washer tried to run the Clean Washer cycle. Remove the load and restart the Clean Washer cycle. If the problem persists, call for service.
Maytag washer F0E7 / Information
F0E7 means clothing was detected while the washer tried to run the Clean Washer cycle. Remove the load and restart the Clean Washer cycle. If the problem persists, call for service.
Also printed as F0E7
F0E7 means clothing was detected while the washer tried to run the Clean Washer cycle. Remove the load and restart the Clean Washer cycle. If the problem persists, call for service.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
F0E7 returns with an empty drum.
Your Maytag to-do list, saved here on this device

The page says remove the clothing or load from the washer.

The manual says to pull back the door seal and check for small items between the tub and the basket. [3]

Start the Clean Washer cycle again with the drum empty.

The manual says not to add detergent to the Clean Washer cycle. [3]

The manual says the washer runs a short sensing cycle of about 3 minutes first. [3]
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The pages headed “F0E7 - Clothes detected” ask whether a clean cycle was selected and say clothing was detected while attempting to run the Clean Washer Cycle.
Read the supporting manualThe manual says the Clean Washer cycle runs a sensing step with some water and a rotating basket, then checks for clothing or other items. If any are detected, a reminder is displayed and the door unlocks.
Read the supporting manualYes. The front-load and top-load pages carry the same text.
Read the supporting manualIt behaves like a reminder. The cure is an empty drum.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-11-19; PH 14595 / PH 14595 (front-load washer)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-01-27; PH 13428 / PH 13428 (top-load washer)
Manufacturer document
Maytag / Whirlpool Corporation (retailer copy of the Use & Care Guide, pdf.lowes.com)
W10254443A; PDF page numbers; retailer copy / PDF p. 14, Washer Maintenance
The Product Help pages list no models, so the text applies to the washer type, not to a named model. Sources: Product Help PH 14595 (front-load), PH 13428 (top-load) and Use & Care Guide W10254443A page 14.
The page says clothing; the manual says clothing or other items.
The manual says the door unlocks when items are detected.
The manual lists an affresh tablet or liquid chlorine bleach for the cycle, not detergent.
Book a visit.
Maytag codes, symptoms, parts and service
F0E5 is an unbalanced load on Maytag washers. The front-load page says a bulky item alone or a tightly packed load can lengthen the cycle and leave clothes dripping; the top-load page says cancel, drain, rearrange and restart.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.