What it means
The Maytag page for H on a range states “An H will display in the heat setting window when any surface cooking area is too hot to touch, even after...” Try the one-minute breaker reset, and schedule a visit if the code returns.
Maytag oven H / User interface
The Maytag page for H on a range states “An H will display in the heat setting window when any surface cooking area is too hot to touch, even after...” Try the one-minute breaker reset, and schedule a visit if the code returns.
Also printed as H
The Maytag page for H on a range states “An H will display in the heat setting window when any surface cooking area is too hot to touch, even after...” Try the one-minute breaker reset, and schedule a visit if the code returns.
While H shows on a range, Power off at the breaker before any panel comes off; a gas smell means getting out and calling the gas utility from outside.
H returns, or the range behaves oddly around the code.
Your Maytag to-do list, saved here on this device

While H shows on a range, Power off at the breaker before any panel comes off; a gas smell means getting out and calling the gas utility from outside.

Check that your appliance is a range and copy H exactly as the display shows it.

Breaker off for one full minute, then back on, and look for H.

Once power is back, keep an eye on the oven for about a minute for H.

Press each key on the range one at a time and note any that do nothing, beep alone or stick.
Note the model and the moment H showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Maytag's range page gives H a single line: “An H will display in the heat setting window when any surface cooking area is too hot to touch, even after the surface cooking area(s) is turned off.” It adds nothing about cause.
Read the supporting manualTurn the oven's circuit breaker off for one minute, switch it back on, then keep an eye on the oven for a further minute to see whether H comes back.
Read the supporting manualC81 is a separate entry from H on the range page, with its own wording.
Read the supporting manualThe range is fine to use only if you can start and stop it with certainty. Never open a panel on the range yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-08-16; PH 13812 / PH 13812 (range)
Scope for H: Maytag range, PH 13812, checked November 2026. Maytag lists no models on the H page.
For H on this range, Maytag's wording is “An H will display in the heat setting window when any surface cooking area is too hot to touch, even after the surface cooking area(s) is turned off.” That is the whole entry.
Yes, give it the whole minute. If H is still there afterward, schedule a visit.
No part is named for H; the page gives only the wording above.
Model and serial numbers plus a note of what happened when H appeared.
Maytag codes, symptoms, parts and service
On a range, the entry for C81 says “The surface cooking area has overheated and the automatic shutoff was activated.” Cut the power for five minutes, then restore it; schedule a visit if the code is still there.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.