Maytag oven Door in Microwave Display / Door and lid

Maytag oven
error code Door in Microwave Display

Oven / display referenceDoor in Microwave Display

On a wall oven, the entry for Door in Microwave Display says “The control is looking for input from the door switches.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.

Also printed as Door in Microwave Display

Last reviewed

Oven / display referenceDoor in Microwave Display
Meaning
On a wall oven, the entry for Door in Microwave Display says “The control is looking for input from the door switches.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.
Who handles it
Information only
Source
Door in Microwave Display - Combination Wall Oven - Product Help | Maytag

What Maytag oven Door in Microwave Display means.

What it means

On a wall oven, the entry for Door in Microwave Display says “The control is looking for input from the door switches.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.

What you can safely check

Turn the breaker off before you touch anything behind a panel.

When to call a technician

Door in Microwave Display returns, or the wall oven behaves oddly around the code.

Your Maytag to-do list, saved here on this device

Safe checks, in order.

0 of 6 checks done
  1. Maytag oven Door in Microwave Display: Cold open wall oven showing the motorized door latch lever, hook and switch behind the top trim, with the power plug lying unplugged on the floor nearby
    Illustration. Follow your model’s instructions.
    Before you begin

    Safety first

    Turn the breaker off before you touch anything behind a panel. If you smell gas, leave the house and call your gas utility from outside.

  2. Ranges & ovens in a thoughtfully designed home
    Illustration. Follow your model’s instructions.
    Check 2

    Match your model

    Check that your appliance is a wall oven and copy Door in Microwave Display exactly as the display shows it.

  3. Close view of a washer control dial and cycle buttons
    Illustration. Follow your model’s instructions.
    Check 3

    Power-cycle it

    Cut power at the breaker for a minute, restore it, then check for Door in Microwave Display.

  4. Over-the-shoulder view of a technician in a navy shirt holding a tablet with five empty checkboxes, a top-load washer behind
    Illustration. Follow your model’s instructions.
    Check 4

    Watch afterward

    Once power is back, keep an eye on the oven for about a minute for Door in Microwave Display.

  5. A technician testing a dryer heating circuit
    Illustration. Follow your model’s instructions.
    Check 5

    Appliance-specific check

    If Door in Microwave Display showed after a self-clean, wait until the wall oven is cool before you touch the door or the latch.

  6. Illustration. Follow your model’s instructions.
    Check 6

    Write it down

    Note the model and the moment Door in Microwave Display showed up; both help us plan.

Does Door in Microwave Display keep coming back?

Give us the model and the checks you have run, then open your request right here.

Book a visit

The door lock.

Conceptual Range / oven sectionDoorLock motor / latchControl123
  1. 1Door

A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.

A little more context.

Which entry in Maytag's wall oven list covers Door in Microwave Display?

Here is what Maytag prints for Door in Microwave Display on a wall oven: “The control is looking for input from the door switches.”

Read the supporting manual

What do I try at home first for Door in Microwave Display?

Take the oven off power at the breaker for a full minute. Put it back on and give it a minute of watching; if Door in Microwave Display stays away, the reset did its job.

Read the supporting manual

Is Door in Microwave Display the same as Beeping or Audio Tones on a wall oven?

Beeping or Audio Tones is a neighbor of Door in Microwave Display, not a synonym. The reset may overlap; the text does not.

Read the supporting manual

Is the wall oven fine to use with Door in Microwave Display on the display?

The page names the latch side, so the lock may not work as it should. Skip self-clean cycles until the wall oven is checked. Never open a panel on the wall oven yourself.

Read the supporting manual

The manual behind the message.

Manufacturer document

Door in Microwave Display - Combination Wall Oven - Product Help | Maytag

Maytag Product Help (producthelp.maytag.com)

dateModified 2024-11-08; PH 14344 / PH 14344 (wall oven)

Scope for Door in Microwave Display: Maytag wall oven, PH 14344, checked November 2026. Maytag lists no models on the Door in Microwave Display page.

Here to help

Good questions.
Clear answers.

Talk to our team
How should I read Door in Microwave Display on my wall oven?

Maytag's wording is “The control is looking for input from the door switches.” That is the whole entry.

Will a one-minute breaker reset clear Door in Microwave Display?

Yes, give it the whole minute. If Door in Microwave Display is still there afterward, schedule a visit.

Does Door in Microwave Display mean something has failed?

Maytag names no part here. Read the message and follow the steps.

What helps most on the first visit for Door in Microwave Display?

The model number, what Door in Microwave Display looked like, and whether the reset changed anything.

Let’s take care of it.

A full hamper waits for no one.
Book the repair.