Inside the appliance
Microwave cavity thermistor (F3C, F4E1). In plain English.
On a Maytag over-the-range microwave, F3C and F4E1 both name the cavity temperature thermistor or its wiring. The printed step is a 60-second power-down at the breaker, a minute of observation and a test run.

Where it fits.
Microwave cavity thermistor (F3C, F4E1) in the appliance
Inside the microwave, wired to the control board. It is not reachable without opening the housing.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Microwave cavity thermistor (F3C, F4E1) trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag microwave will not start
If a Maytag microwave will not start, the display usually explains why: a door message, the LOC padlock icon, or Demo Mode. Reopen and reclose the door first, then check the lock and demo settings before you book a visit.

Maytag countertop microwave control panel bubbling
Bubbles on the control panel of a Maytag countertop microwave are usually the clear protective film that ships over the panel. Lift one corner with a fingernail and peel it off; there may be more than one layer. If the panel still looks raised, book a technician.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Read the code
F3C and F4E1 use the same thermistor wording.
- 2
Reset at the breaker
Sixty seconds without power, then restore it.
- 3
Monitor for a minute
See if the code reappears.
- 4
Run a cycle
Confirm the microwave operates.
Cleaning or replacement?
Leave internal testing to a technician.
F3C or F4E1 returns after the reset.
Convection or heat functions stop working.
The cavity smells hot or scorched.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Microwave cavity thermistor (F3C, F4E1) advice. Read the manual for your own model.
- F3C - Error Code - Over-the-Range Microwave - Product Help | Maytag
- F4E1 - Error Code - Over-the-Range Microwave - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
What does F3C mean?
Product Help ties it to the cavity temperature thermistor or its wiring, as a possibility.
Is F4E1 different?
It prints the same cavity thermistor wording and the same reset.
Can I replace it myself?
Product Help does not give that step. It is a part for a technician to test and swap.
What should I do first?
Cut power at the breaker for 60 seconds, restore it and observe.
Maytag codes, symptoms, parts and service
From the message to what you do next.
F3C
Maytag words F3C as a possible problem with the cavity temperature thermistor or its wiring. Reset at the breaker for one minute and monitor for one minute. F4E1 names the same part under a different code.
Maytag microwave will not start
If a Maytag microwave will not start, the display usually explains why: a door message, the LOC padlock icon, or Demo Mode. Reopen and reclose the door first, then check the lock and demo settings before you book a visit.
Microwave repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

