Inside the appliance

Dishwasher float switch and drip tray (F8E4, F6E4). In plain English.

F8E4 on a Maytag dishwasher means water was detected in the drip tray. Product Help checks the water connections, whether the float switch is reconnected, and whether the tray holds water that needs to be emptied. F6E4 names the water float switch and asks you to level the dishwasher.

Last reviewed

Cream plastic drip tray pulled out from under a stainless dishwasher, holding a small round float with a wire lead
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Where it fits.

Dishwasher float switch and drip tray (F8E4, F6E4) in the appliance

In the drip pan assembly under the dishwasher, per the F8E4 page. Take care: the float switch wire stays attached when you pull the tray.

This image is an example of the component type. It will not tell you which replacement is right for your model.

How you can tell this system is asking for attention.

Dishwasher float switch and drip tray (F8E4, F6E4) trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Owner care, within the model instructions.

Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.

  1. 1

    Look for leaks

    Check every water connection point, seated washers, hand-tightened coupling.

  2. 2

    Reconnect the float switch

    Line up the connector and press it home until the locking tab appears. Keep the power wire away from the motor and tub base.

  3. 3

    Empty the tray

    Squeeze the snaps on both sides of the plastic tray inward and draw it out gently. Do not yank it; the wire is still attached.

  4. 4

    Level the dishwasher

    F6E4 starts with a level check, then a 30-second power cycle.

Cleaning or replacement?

Leave internal testing to a technician.

F8E4 reappears with the tray empty and dry.

Water keeps reaching the tray.

Suds come out of the dishwasher.

Arrange a diagnostic

Sources and model boundaries.

These sources stand behind the Dishwasher float switch and drip tray (F8E4, F6E4) advice. Read the manual for your own model.

  • Dishwasher Error Codes - Reading - Product Help | Maytag
  • 8 Pause 4 Pause - pause, repeat - Error Code - Dishwasher - Product Help | Maytag
  • F6E4- Dishwasher - Product Help | Maytag

Follow the guide for your own model, and see how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
What does F8E4 mean?

Water Detected in Drip Tray, according to Maytag's dishwasher error code list.

Should I check this on a new install?

Yes. The pages have a section for recently installed or self-installed dishwashers: connections and the float switch first.

Can excess suds trigger it?

Product Help lists "Are there excessive suds?" on one F8E4 page, so yes, check for foam.

What does F6E4 add?

The cause is a Water Float Switch. The page says to level the dishwasher and cycle power.

Let’s take care of it.

A full hamper waits for no one.
Book the repair.