What it means
For a top-load washer showing Spin Light Flashing, Maytag prints “Suppose the load is not evenly distributed in the basket when spinning begins.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Maytag washer Spin Light Flashing / Information
For a top-load washer showing Spin Light Flashing, Maytag prints “Suppose the load is not evenly distributed in the basket when spinning begins.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Also printed as Spin Light Flashing
For a top-load washer showing Spin Light Flashing, Maytag prints “Suppose the load is not evenly distributed in the basket when spinning begins.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Power and water off before any panel comes off; towels down for spills.
Spin Light Flashing returns, or the top-load washer behaves oddly around the code.
Your Maytag to-do list, saved here on this device

Power and water off before any panel comes off; towels down for spills.

Record Spin Light Flashing character by character and note the product type: top-load washer.

Wait five minutes without power before you check for Spin Light Flashing again.

Run the washer briefly after the reset and see whether Spin Light Flashing comes back.

Open the top-load washer and spread the load evenly; very small or very heavy loads can unbalance a spin.
Note the model and the moment Spin Light Flashing showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for Spin Light Flashing on a top-load washer: “Suppose the load is not evenly distributed in the basket when spinning begins.”
Read the supporting manualMaytag asks for five minutes without power. Wait the full time, restore power, and note whether Spin Light Flashing reappears.
Read the supporting manualThe top-load washer list prints Rinse Light On next to Spin Light Flashing, but with a different line. Look up the one on your display.
Read the supporting manualAn unbalanced load is usually a loading matter; the top-load washer is safe to use once the load is redistributed.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-07-15; PH 13145 / PH 13145 (top-load washer)
Spin Light Flashing comes from Maytag Product Help (PH 13145) for the top-load washer, read in November 2026; the Spin Light Flashing entry names no models.
The top-load washer page reads “Suppose the load is not evenly distributed in the basket when spinning begins.” It prints nothing more about cause.
Wait the whole five minutes, not less. If Spin Light Flashing persists, a technician should look.
Not by itself; the page stops at the line it prints.
Tell us the model, the display wording and when Spin Light Flashing first showed up.
Maytag codes, symptoms, parts and service
Maytag's top-load washer page words Rinse Light On like this: “Certain cycles use a spray rinse, which adds water to the tub while the basket spins.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.