What it means
Fd means Factory Default: Maytag’s top-load page says the washer was returned to factory default settings. The display shows Fd for 3 seconds, then the washer returns to Standby Mode. It is not an error that needs a repair.
Maytag washer Fd / Information
Fd means Factory Default: Maytag’s top-load page says the washer was returned to factory default settings. The display shows Fd for 3 seconds, then the washer returns to Standby Mode. It is not an error that needs a repair.
Also printed as Fd
Fd means Factory Default: Maytag’s top-load page says the washer was returned to factory default settings. The display shows Fd for 3 seconds, then the washer returns to Standby Mode. It is not an error that needs a repair.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
Fd appears without anyone entering the sequence.
Your Maytag to-do list, saved here on this device

The display shows Fd for 3 seconds and then the unit returns to Standby Mode.

All options and modifiers were returned to factory default.

Press POWER/CANCEL, select the Drain & Spin cycle, then press Extra Rinse, Fabric Softener, Extra Rinse, Fabric Softener within 5 seconds.

The sequence is long, so an accidental reset is unlikely but possible.

Set your usual options again.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Fd means Factory Default settings. The code indicates the washer was returned to factory default settings.
Read the supporting manualThe page gives the sequence: press POWER/CANCEL, select Drain & Spin, then press Extra Rinse, Fabric Softener, Extra Rinse, Fabric Softener within 5 seconds. When done correctly, the 7-segment displays show Fd for 3 seconds.
Read the supporting manualNo problem is described. It confirms that the reset worked.
Read the supporting manualTell us. The page describes only the deliberate sequence.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-07-03; PH 13150 / PH 13150 (top-load washer)
The Product Help pages list no models, so the text applies to the washer type, not to a named model. Source: Product Help PH 13150 (top-load washer, Other Error Codes).
It is listed under Other Error Codes, but the text describes a reset result.
It returns all options and modifiers to default.
3 seconds.
Only if the sequence is repeated.
Maytag codes, symptoms, parts and service
For a top-load washer showing Wash Light On or Flashing, Maytag prints “The Wash Light is on or flashing when the water level has not changed for a while, OR water is present, but...” No reset is printed for it, so schedule a visit if it keeps appearing.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.