F7E1 on a Maytag front-load washer is explained as “This code indicates a motor speed sensing error, the motor can not achieve the correct speed for the cycle...” Try the five-minute power-off reset, and schedule a visit if the code returns.
F7E1 on a Maytag front-load washer is explained as “This code indicates a motor speed sensing error, the motor can not achieve the correct speed for the cycle...” Try the five-minute power-off reset, and schedule a visit if the code returns.
F7E1 on a Maytag front-load washer is explained as “This code indicates a motor speed sensing error, the motor can not achieve the correct speed for the cycle...” Try the five-minute power-off reset, and schedule a visit if the code returns.
What you can safely check
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
When to call a technician
F7E1 repeats after the reset.
Your Maytag to-do list, saved here on this device
Safe checks, in order.
0 of 6 checks done
Illustration. Follow your model’s instructions.
Before you begin
Safety first
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
Illustration. Follow your model’s instructions.
Check 2
Match your model
Record F7E1 character by character and note the product type: front-load washer.
Illustration. Follow your model’s instructions.
Check 3
Power-cycle it
Power off for five full minutes, then on, and look for F7E1.
Illustration. Follow your model’s instructions.
Check 4
Watch afterward
Run the washer briefly after the reset and see whether F7E1 comes back.
Illustration. Follow your model’s instructions.
Check 5
Appliance-specific check
Take half the load out and try a short rinse or spin.
Illustration. Follow your model’s instructions.
Check 6
Have this ready
Note the model and the moment F7E1 showed up; both help us plan.
Does F7E1 keep coming back?
Give us the model and the checks you have run, then open your request right here.
F7E1 is covered by this wording on the front-load washer page: “This code indicates a motor speed sensing error, the motor can not achieve the correct speed for the cycle selection.”
On the front-load washer page the line is “This code indicates a motor speed sensing error, the motor can not achieve the correct speed for the cycle selection.” No further cause is given.
Should I power the front-load washer down for F7E1?
Wait the whole five minutes, not less. If F7E1 persists, a technician should look.
Is a specific part blamed for F7E1?
Not by itself; the page stops at the line it prints.
What should I have ready when I schedule for F7E1?
Tell us the model, the display wording and when F7E1 first showed up.