What it means
On a range, the entry for Probe or Insert Probe says “The Control is 'looking' for an input from the Meat Probe.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.
Maytag oven Probe or Insert Probe / Sensors
On a range, the entry for Probe or Insert Probe says “The Control is 'looking' for an input from the Meat Probe.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.
Also printed as Probe or Insert Probe
On a range, the entry for Probe or Insert Probe says “The Control is 'looking' for an input from the Meat Probe.” Switch the breaker off for a minute, then back on; schedule a visit if the code is still there.
Turn the breaker off before you touch anything behind a panel.
Probe or Insert Probe repeats after the reset.
Your Maytag to-do list, saved here on this device

Turn the breaker off before you touch anything behind a panel. If you smell gas, leave the house and call your gas utility from outside.

Match the label on your appliance to the range list before you rely on the wording for Probe or Insert Probe.

Breaker off for one full minute, then back on, and look for Probe or Insert Probe.

Give the oven a minute on screen after the reset; a returning Probe or Insert Probe means schedule a visit.

Use only the probe made for the range.
Note the model and the moment Probe or Insert Probe showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visit


A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Probe or Insert Probe is covered by this wording on the range page: “The Control is 'looking' for an input from the Meat Probe.”
Read the supporting manualMaytag's reset is a minute at the breaker: off, wait, on. Then leave the oven in view for another minute and note whether Probe or Insert Probe returns.
Read the supporting manualThe range list prints Press Cancel to Reset next to Probe or Insert Probe, but with a different line. Look up the one on your display.
Read the supporting manualRemove the probe and carry on. Never open a panel on the range yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-07; PH 13884 / PH 13884 (range)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14349 / PH 14349 (wall oven)
Facts for Probe or Insert Probe are from the range table (PH 13884) of Maytag Product Help, checked November 2026; no model list is printed.
The help page states “The Control is 'looking' for an input from the Meat Probe.” Nothing else is added.
Yes, give it the whole minute. If Probe or Insert Probe is still there afterward, schedule a visit.
Not by itself; the page stops at the line it prints.
Model and serial numbers plus a note of what happened when Probe or Insert Probe appeared.
Maytag codes, symptoms, parts and service
"Press Cancel to Reset" is a plain instruction: press the Cancel button or pad. Maytag says the message appears when a fault or error has been detected. If Call Service then shows, do the one-minute breaker reset and start a bake cycle.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.