What it means
On a range, the entry for Pre says “On some models, once the temperature reaches 170° F, the display will show the temperature and will increase...” Nothing else is printed, so schedule a visit if it repeats.
Maytag oven Pre / Display and signals
On a range, the entry for Pre says “On some models, once the temperature reaches 170° F, the display will show the temperature and will increase...” Nothing else is printed, so schedule a visit if it repeats.
Also printed as Pre
On a range, the entry for Pre says “On some models, once the temperature reaches 170° F, the display will show the temperature and will increase...” Nothing else is printed, so schedule a visit if it repeats.
Turn the breaker off before you touch anything behind a panel.
Pre will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Turn the breaker off before you touch anything behind a panel. If you smell gas, leave the house and call your gas utility from outside.

Check that your appliance is a range and copy Pre exactly as the display shows it.

Maytag prints no reset for Pre, so record what the oven does rather than guessing a fix.

Keep the model number close and note when Pre appeared and what the range was doing.

Ask whether Pre is a mode someone switched on; Maytag describes it as a setting.
Keep the model number close and note when Pre appeared and what the range was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for Pre on a range: “On some models, once the temperature reaches 170° F, the display will show the temperature and will increase in 5° increments.”
Read the supporting manualMaytag's page for Pre gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the oven shows.
Read the supporting manualThe range list prints Locked next to Pre, but with a different line. Look up the one on your display.
Read the supporting manualNothing is wrong when Pre is a mode message.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-07; PH 13885 / PH 13885 (range)
Facts for Pre are from the range table (PH 13885) of Maytag Product Help, checked November 2026; no model list is printed.
Maytag's wording is “On some models, once the temperature reaches 170° F, the display will show the temperature and will increase in 5° increments.” That is the whole entry.
Nothing is printed for it, so record the display and schedule us if Pre continues.
Not by itself; the page stops at the line it prints.
Model and serial numbers plus a note of what happened when Pre appeared.
Maytag codes, symptoms, parts and service
Maytag's range page words Flashing Time, Clock, 12:00, Power Loss or Enter Time like this: “When power is first supplied to the oven, after a power interruption or failure, the 'Time', or '12:00', or...” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.