What it means
F06 on your range is tied by Maytag to the electronic control or the wiring. One reset costs nothing; if the code survives it, schedule a visit.
Maytag oven F06 / Control board
F06 on your range is tied by Maytag to the electronic control or the wiring. One reset costs nothing; if the code survives it, schedule a visit.
Also printed as F06
F06 on your range is tied by Maytag to the electronic control or the wiring. One reset costs nothing; if the code survives it, schedule a visit.
Turn the breaker off before you touch anything behind a panel.
F06 will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Turn the breaker off before you touch anything behind a panel. If you smell gas, leave the house and call your gas utility from outside.

Match the label on your appliance to the range list before you rely on the wording for F06.

Breaker off for one full minute, then back on, and look for F06.

Once power is back, keep an eye on the oven for about a minute for F06.

The control board lives behind panels on the range; keep them closed.
Keep the model number close and note when F06 appeared and what the range was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit

A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
For F06 the range entry names the electronic control or the wiring. Nothing in it says which of them has failed.
Read the supporting manualTake the oven off power at the breaker for a full minute. Put it back on and give it a minute of watching; if F06 stays away, the reset did its job.
Read the supporting manualRead the exact display: F05 means the door latch assembly, the door switch or the wiring on the range page, and F06 means the electronic control or the wiring.
Read the supporting manualA control problem can stop heating or cause odd behavior, so stay near the range while it runs. If F06 keeps returning, stop and schedule a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-08-16; PH 13743 / PH 13743 (range)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2024-11-08; PH 14402 / PH 14402 (wall oven)
Scope for F06: Maytag range, PH 13743, checked November 2026. Maytag lists no models on the F06 page.
Maytag names the electronic control or the wiring and gives no test to choose between them.
Try it first: one minute off, one minute on screen. If F06 persists, a technician should look.
The list is the electronic control or the wiring; testing on site settles it.
Model and serial numbers plus a note of what happened when F06 appeared.
Maytag codes, symptoms, parts and service
The Maytag range entry for F05 names the door latch assembly, the door switch or the wiring. Reset first, then call us in if the code keeps coming back.
A Maytag steam wall oven asks you to "Empty and Refill Water Container" before each steam cycle, "Descale is needed" when it needs cleaning, and "Please remove and empty container" at the end of a descale. Treat each as a request rather than a breakdown, carry it out, and book a visit if one keeps returning.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.