What it means
F1E1 on a Maytag dishwasher is explained as “Potential Cause: Control Module.” Cut the power for 30 seconds, then restore it; schedule a visit if the code is still there.
Maytag dishwasher F1E1 / Control board
F1E1 on a Maytag dishwasher is explained as “Potential Cause: Control Module.” Cut the power for 30 seconds, then restore it; schedule a visit if the code is still there.
Also printed as F1E1
F1E1 on a Maytag dishwasher is explained as “Potential Cause: Control Module.” Cut the power for 30 seconds, then restore it; schedule a visit if the code is still there.
Switch off power and the water supply before opening anything, and wipe up spills so nobody slips.
F1E1 will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Switch off power and the water supply before opening anything, and wipe up spills so nobody slips.

Match the label on your appliance to the dishwasher list before you rely on the wording for F1E1.

Wait a full thirty seconds without power before you check for F1E1 again.

Once power is back, keep an eye on the dishwasher for about a minute for F1E1.

Make sure the door of the dishwasher latches and nothing blocks it.
Write down the model and serial numbers and the exact F1E1 wording before you call.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for F1E1 on a dishwasher: “Potential Cause: Control Module.”
Read the supporting manualMaytag's reset is thirty seconds without power. Count it out, restore power, and look for F1E1.
Read the supporting manualThe dishwasher list prints FAE5 next to F1E1, but with a different line. Look up the one on your display.
Read the supporting manualDo not rerun the dishwasher repeatedly with F1E1 showing.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2026-06-15; PH 12608 / PH 12608 (dishwasher)
Manufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2026-06-15; PH 12623 / PH 12623 (dishwasher)
F1E1 comes from Maytag Product Help (PH 12608) for the dishwasher, read in November 2026; the F1E1 entry names no models.
The help page states “Potential Cause: Control Module.” Nothing else is added.
Count the half minute, restore power and watch. If F1E1 persists, a technician should look.
Not by itself; the page stops at the line it prints.
The model and serial numbers, the exact display for F1E1, and what the dishwasher was doing at the time.
Maytag codes, symptoms, parts and service
Maytag prints FAE5 or F10E5 as “Potential Cause: Diverter Leak.” Check for leaks under the dishwasher, make sure the water connections are secure, press Cancel twice and try a new cycle. If the error returns, schedule service.
A burnt smell from a Maytag dishwasher is often plastic or food that fell by the heating element. Let the tub cool for at least 30 minutes, clear the debris, and run a rinse or cleaning cycle. A hot tar or petroleum smell on a new dishwasher is the sound-deadening coating and should fade in 4 to 6 weeks.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.