What it means
Control Light Flashing on a Maytag dishwasher is explained as “The light will flash three times if any buttons are pressed while the controls are locked.” Try the 30-second power-off reset, and schedule a visit if the code returns.
Maytag dishwasher Control Light Flashing / Control board
Control Light Flashing on a Maytag dishwasher is explained as “The light will flash three times if any buttons are pressed while the controls are locked.” Try the 30-second power-off reset, and schedule a visit if the code returns.
Also printed as Control Light Flashing
Control Light Flashing on a Maytag dishwasher is explained as “The light will flash three times if any buttons are pressed while the controls are locked.” Try the 30-second power-off reset, and schedule a visit if the code returns.
Close the water valve and the breaker before any panel comes off.
Control Light Flashing will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Close the water valve and the breaker before any panel comes off.

Record Control Light Flashing character by character and note the product type: dishwasher.

Wait a full thirty seconds without power before you check for Control Light Flashing again.

Once power is back, keep an eye on the dishwasher for about a minute for Control Light Flashing.

Look in the tub for standing water, and check the filter and spray arm for blockage.
Note the model and the moment Control Light Flashing showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Control Light Flashing is covered by this wording on the dishwasher page: “The light will flash three times if any buttons are pressed while the controls are locked.”
Read the supporting manualCut power to the dishwasher for 30 seconds, then restore it and check whether Control Light Flashing returns.
Read the supporting manualClean Light Flashing is a separate entry from Control Light Flashing on the dishwasher page, with its own wording.
Read the supporting manualDo not rerun the dishwasher repeatedly with Control Light Flashing showing.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-05-27; PH 14545 / PH 14545 (dishwasher)
Facts for Control Light Flashing are from the dishwasher table (PH 14545) of Maytag Product Help, checked November 2026; no model list is printed.
The dishwasher page reads “The light will flash three times if any buttons are pressed while the controls are locked.” It prints nothing more about cause.
Yes, run it as printed and schedule a visit if Control Light Flashing stays.
Maytag names no part here. Read the message and follow the steps.
The model number, what Control Light Flashing looked like, and whether the reset changed anything.
Maytag codes, symptoms, parts and service
Maytag's dishwasher page words Clean Light Flashing like this: “Maytag dishwashers use a two-part flashing sequence to communicate specific errors.” No reset is printed for it, so schedule a visit if it keeps appearing.
A burnt smell from a Maytag dishwasher is often plastic or food that fell by the heating element. Let the tub cool for at least 30 minutes, clear the debris, and run a rinse or cleaning cycle. A hot tar or petroleum smell on a new dishwasher is the sound-deadening coating and should fade in 4 to 6 weeks.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.