Inside the appliance
Top-load washer balance ring. In plain English.
The balance ring on a Maytag top-load washer is a fluid-filled ring at the top of the tub. As a load shifts, the fluid moves to the opposite side to steady the basket and allow faster spins. Product Help says it is the usual cause of water heard but not seen, and it may slosh when you move the washer.

Where it fits.
Top-load washer balance ring in the appliance
At the top of the tub, per Product Help. It is not a part you service at home.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Top-load washer balance ring trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag washer not draining
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.

Maytag washer leaking water
Where the puddle sits tells you where to look. Water under a Maytag washer most often comes from a loose inlet hose connection, a backed-up household drain, or a cracked hose. Tighten and inspect those first. If the washer is dry at the hoses and still leaks, book a technician.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Listen for the sound
Water heard in the tub but not seen is normally the balance ring, per Product Help.
- 2
Spread the load
A tightly packed or lopsided load can leave clothes wetter. Redistribute it.
- 3
Use Rinse and Spin
Product Help suggests Rinse & Spin to remove extra water from a tightly packed load.
- 4
Check the drain hose
If water is truly left in the tub, the drain hose comes next, not the ring.
Cleaning or replacement?
Leave internal testing to a technician.
You see standing water, not just hear it.
The washer shakes hard or walks even with a balanced load.
A thump or clunk continues with a small load.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Top-load washer balance ring advice. Read the manual for your own model.
- Not Draining - Washer - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
Is sloshing in an empty tub normal?
Product Help says you may also hear the balance ring fluid when you move the washer. It is not leaking water.
What does the balance ring do?
It shifts fluid opposite the heavy side of the load to steady the basket and allow higher spin speeds.
Can I drain the ring?
Product Help gives no steps for it, so leave it alone.
When is it a drain problem?
When water is seen in the tub after the cycle. Then check the drain hose, detergent type and load packing.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag washer not draining
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Washer repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

