Inside the appliance
Range oven cooling fan. In plain English.
A Maytag range carries a cooling fan whose job is to protect the oven cavity and electronics from heat during BAKE, BROIL and CLEAN. Product Help says it can keep spinning for a long while after the oven goes off. A Cooling Fan Speed message means its speed is off.

Where it fits.
Range oven cooling fan in the appliance
Product Help does not place the fan inside the cabinet.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Range oven cooling fan trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag range and oven noises
Most oven noises on a Maytag range are ordinary working sounds. Clicking is the ignitor trying to light the flame, and a fan that runs during and after cooking is the convection or cooling fan. Open the door to tell them apart: the convection fan stops, the cooling fan keeps going.

Maytag range self-clean cycle not working
A Maytag range self-clean that will not begin is usually waiting on the oven or the door. Too hot and it will not start: AquaLift needs the cavity under 200 degrees F, steam clean under 170 degrees F. On a high-temperature clean the door must close completely or it will not lock. Check which cycle your range has.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Tell the two fans apart
Open the door. If the noise stops it was the convection fan; if it carries on it is the cooling fan.
- 2
Give it time
Long run time after a cycle is normal and depends on temperatures inside and out.
- 3
Reset for the speed message
De-energize the range circuit for sixty seconds, restore it, and look at the display again after another sixty.
- 4
Think about airflow
Maytag names three suspects: something limiting airflow, the fan unit, or associated wiring.
Cleaning or replacement?
Leave internal testing to a technician.
The Cooling Fan Speed message repeats after power is restored.
The fan howls or does not spin when the oven is hot.
The control panel gets very warm.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Range oven cooling fan advice. Read the manual for your own model.
- Cooling Fan Speed - Range - Product Help | Maytag
- Fan Noise - Convection - Range - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
Should the fan still spin once baking ends?
Yes. Maytag expects the cooling fan to run during use and after the cycle, sometimes for an extended time.
What does Cooling Fan Speed tell me?
The fan speed reads out of range, low or high; Maytag names airflow, the fan unit or wiring.
Which fan am I hearing?
Open the oven door. If the sound stops it is the convection fan; if not, the cooling fan.
What reset is printed?
Cut the circuit for sixty seconds, restore it, and watch the oven another sixty.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag range and oven noises
Most oven noises on a Maytag range are ordinary working sounds. Clicking is the ignitor trying to light the flame, and a fan that runs during and after cooking is the convection or cooling fan. Open the door to tell them apart: the convection fan stops, the cooling fan keeps going.
Range repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

