Inside the appliance
Range bake and broil elements. In plain English.
A Maytag electric range pulses its bake and broil elements as part of normal operation. A limiter does this at higher settings so nothing overheats, and with the oven door open the elements stay off. Opening the door while broiling drops the broil element immediately.

Where it fits.
Range bake and broil elements in the appliance
Product Help does not locate the elements; they are inside the oven cavity.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Range bake and broil elements trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag range and oven noises
Most oven noises on a Maytag range are ordinary working sounds. Clicking is the ignitor trying to light the flame, and a fan that runs during and after cooking is the convection or cooling fan. Open the door to tell them apart: the convection fan stops, the cooling fan keeps going.

Maytag range self-clean cycle not working
A Maytag range self-clean that will not begin is usually waiting on the oven or the door. Too hot and it will not start: AquaLift needs the cavity under 200 degrees F, steam clean under 170 degrees F. On a high-temperature clean the door must close completely or it will not lock. Check which cycle your range has.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Expect the clicking
Elements pulsing on and off through a cycle are working as intended.
- 2
Shut the door properly
Some models hold the elements off until the door latches shut.
- 3
Broil and the door
Opening the door during broil cuts the element; it returns when the door shuts.
- 4
Adjust your timing
Cook times may differ from your previous oven even though its temperatures are accurate.
Cleaning or replacement?
Leave internal testing to a technician.
An element never glows with the door closed.
Bake stays cold.
An F code appears.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Range bake and broil elements advice. Read the manual for your own model.
- Oven Elements Turning On/Off - Electric Range - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
Should the oven element switch off mid-cycle?
Yes. Maytag says a limiter lets bake and broil elements pulse at higher settings to prevent overheating.
Why is the element dark?
Some models keep it off while the door is ajar. Close the door fully.
What if I peek during broiling?
The broil element drops out instantly and resumes when the door closes.
Why do my recipes cook differently now?
Product Help says cook times may not match your previous oven's.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag range and oven noises
Most oven noises on a Maytag range are ordinary working sounds. Clicking is the ignitor trying to light the flame, and a fan that runs during and after cooking is the convection or cooling fan. Open the door to tell them apart: the convection fan stops, the cooling fan keeps going.
Range repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

