What it means
Maytag's top-load washer page words F7E4 like this: “F7E4 - Shifter.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Maytag washer F7E4 / Motor and drive
Maytag's top-load washer page words F7E4 like this: “F7E4 - Shifter.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Also printed as F7E4
Maytag's top-load washer page words F7E4 like this: “F7E4 - Shifter.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.
F7E4 repeats after the reset.
Your Maytag to-do list, saved here on this device

Unplug the machine or switch off its breaker before opening any panel, close the water taps, and keep floors dry so nobody slips.

Match the label on your appliance to the top-load washer list before you rely on the wording for F7E4.

Power off for five full minutes, then on, and look for F7E4.

Give the washer a minute on screen after the reset; a returning F7E4 means schedule a visit.
Write down the exact words or symbols the top-load washer shows before you do anything.
Keep the model number close and note when F7E4 appeared and what the top-load washer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Maytag's top-load washer page gives F7E4 a single line: “F7E4 - Shifter.” It adds nothing about cause.
Read the supporting manualMaytag asks for five minutes without power. Wait the full time, restore power, and note whether F7E4 reappears.
Read the supporting manualThe top-load washer list prints F7E0 next to F7E4, but with a different line. Look up the one on your display.
Read the supporting manualWhether the top-load washer is safe depends on how it behaves, not the message alone.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-05-27; PH 13452 / PH 13452 (top-load washer)
F7E4 comes from Maytag Product Help (PH 13452) for the top-load washer, read in November 2026; the F7E4 entry names no models.
With F7E4 on the top-load washer, the help page states “F7E4 - Shifter.” Nothing else is added.
It may. Cut power for the full five minutes, restore it and watch. If it returns, schedule a visit.
Maytag prints nothing about replacing parts here.
Tell us the model, the display wording and when F7E4 first showed up.
Maytag codes, symptoms, parts and service
Maytag’s top-load washer page for F7E0 (PH 13449) prints no meaning for the code, only a reset: cut power to the washer for five minutes, then restore it. Book a visit if F7E0 returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.