What it means
Loc on a Maytag dryer is explained as “The Loc Error code indicates that the Control Lock has been enabled.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Maytag dryer Loc / Display and signals
Loc on a Maytag dryer is explained as “The Loc Error code indicates that the Control Lock has been enabled.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Also printed as Loc
Loc on a Maytag dryer is explained as “The Loc Error code indicates that the Control Lock has been enabled.” Maytag prints no reset for it; if it keeps appearing, schedule a visit.
Power off before any panel comes off; lint and burnt smells mean stop and leave the dryer off.
Loc will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Power off before any panel comes off; lint and burnt smells mean stop and leave the dryer off.

Record Loc character by character and note the product type: dryer.

No reset is printed here; note the behavior of the dryer around Loc instead.

Keep the model number close and note when Loc appeared and what the dryer was doing.
Open the door or lid of the dryer fully and close it again firmly; check nothing is caught in the seal or latch area.
Keep the model number close and note when Loc appeared and what the dryer was doing.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
Here is what Maytag prints for Loc on a dryer: “The Loc Error code indicates that the Control Lock has been enabled.”
Read the supporting manualMaytag's page for Loc gives no reset or checking steps, so there is no page-approved first move beyond noting exactly what the dryer shows.
Read the supporting manualThe dryer list prints ERR next to Loc, but with a different line. Look up the one on your display.
Read the supporting manualIf the door will not open, leave the dryer off and book us rather than prying. Never open a panel on the dryer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2023-12-07; PH 12838 / PH 12838 (dryer)
Scope for Loc: Maytag dryer, PH 12838, checked November 2026. Maytag lists no models on the Loc page.
For Loc on this dryer, the help page states “The Loc Error code indicates that the Control Lock has been enabled.” Nothing else is added.
No; Maytag gives Loc no reset steps. If it repeats, schedule a visit.
Not by itself; the page stops at the line it prints.
Tell us the model, the display wording and when Loc first showed up.
Maytag codes, symptoms, parts and service
On a dryer, the entry for ERR says “You will receive the 'ERR' error code when the door has not been completely closed and latched; the dryer...” Cut the power for five minutes, then restore it; schedule a visit if the code is still there.
A Maytag dryer that does nothing is usually a power, lock or latch issue before it is a broken part. An electric dryer draws on two breakers or fuses and needs 240 volts, the Control Lock may be on, and the door may look shut without latching. Check these, then book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.