What it means
On a front-load washer, F7EC asks first whether the washer is overloaded. Avoid tightly packing the load; clothing should move freely. Then cut power for 5 minutes and restart. If F7EC returns with a lighter load, schedule a visit.
Maytag washer F7EC / Information
On a front-load washer, F7EC asks first whether the washer is overloaded. Avoid tightly packing the load; clothing should move freely. Then cut power for 5 minutes and restart. If F7EC returns with a lighter load, schedule a visit.
Also printed as F7EC
On a front-load washer, F7EC asks first whether the washer is overloaded. Avoid tightly packing the load; clothing should move freely. Then cut power for 5 minutes and restart. If F7EC returns with a lighter load, schedule a visit.
Power and water off before any panel comes off; towels down for spills.
F7EC returns with a light load after the reset.
Your Maytag to-do list, saved here on this device

The page asks if the washer is overloaded. Take out items until clothing can move freely.

Avoid tightly packing the load.

Unplug the washer for 5 minutes, or switch off its breaker for 5 minutes, then restore power.

See whether F7EC returns.

The page says overloading can cause extra wear and tear on the machine and on the garment.
Give us the model and the checks you have run, then open your request right here.
Book a visit
A rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
The page asks “Is the washer overloaded?” and says to avoid tightly packing the load, since clothing should move freely, and that overloading can cause extra wear and tear on the machine as well as on the garment.
Read the supporting manualNo. It gives no definition of the code, only the load advice and the 5-minute reset.
Read the supporting manualF0E3 on the top-load tree is an explicit overload code with a recovery cycle. F7EC is a front-load code that asks the overload question.
Read the supporting manualIf the code returns with a light load after the reset, book a visit.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2025-11-19; PH 14625 / PH 14625 (front-load washer)
The Product Help pages list no models, so the text applies to the washer type, not to a named model. Source: Product Help PH 14625 (front-load).
The page asks about overload but does not call it that.
Maytag gives no measure. Clothing should move freely.
The page says overloading can add wear and tear.
5 minutes.
Maytag codes, symptoms, parts and service
Maytag’s front-load washer page for F7EA (PH 14624) prints no meaning for the code, only a reset: cut power to the washer for five minutes, then restore it. Book a visit if F7EA returns.
A Maytag washer that leaves water in the tub usually points to the drain setup before the machine itself: a hose pushed too far into the standpipe, a standpipe under 30 inches, tape sealing the hose, or a clogged drain pump filter. Check those first; if water still stays, book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.