What it means
On a commercial-grade residential dryer, the entry for F70 says “Power unit down by turning off the circuit breaker(s) for 5 minutes.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Maytag dryer F70 / Reset only
On a commercial-grade residential dryer, the entry for F70 says “Power unit down by turning off the circuit breaker(s) for 5 minutes.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Also printed as F70
On a commercial-grade residential dryer, the entry for F70 says “Power unit down by turning off the circuit breaker(s) for 5 minutes.” Try the five-minute power-off reset, and schedule a visit if the code returns.
Unplug the dryer or switch off its breaker before opening any panel, clean lint regularly, and if you smell gas leave the house and call your gas utility.
F70 will not clear after one proper reset.
Your Maytag to-do list, saved here on this device

Unplug the dryer or switch off its breaker before opening any panel, clean lint regularly, and if you smell gas leave the house and call your gas utility.

Record F70 character by character and note the product type: commercial-grade residential dryer.

Wait five minutes without power before you check for F70 again.

Give the dryer a minute on screen after the reset; a returning F70 means schedule a visit.

Note when F70 appears: at start, mid-cycle or after a power cut.
Note the model and the moment F70 showed up; both help us plan.
Give us the model and the checks you have run, then open your request right here.
Book a visitA rough sketch only, because a Maytag is laid out differently from model to model. Click a highlighted part to open its photo and the matching test.
F70 is covered by this wording on the commercial-grade residential dryer page: “Power unit down by turning off the circuit breaker(s) for 5 minutes.”
Read the supporting manualMaytag asks for five minutes without power. Wait the full time, restore power, and note whether F70 reappears.
Read the supporting manualF50 is a separate entry from F70 on the commercial-grade residential dryer page, with its own wording.
Read the supporting manualUse the commercial-grade residential dryer if it behaves normally; stop if there are odd noises, smells or heat. Never open a panel on the commercial-grade residential dryer yourself.
Read the supporting manualManufacturer document
Maytag Product Help (producthelp.maytag.com)
dateModified 2021-07-28; PH 11831 / PH 11831 (commercial-grade residential dryer)
Facts for F70 are from the commercial-grade residential dryer table (PH 11831) of Maytag Product Help, checked November 2026; no model list is printed.
The help page states “Power unit down by turning off the circuit breaker(s) for 5 minutes.” Nothing else is added.
Wait the whole five minutes, not less. If F70 persists, a technician should look.
Not by itself; the page stops at the line it prints.
Tell us the model, the display wording and when F70 first showed up.
Maytag codes, symptoms, parts and service
The Maytag page for F50 on a commercial-grade residential dryer states “Power unit down by turning off the circuit breaker(s) for 5 minutes.” Try the five-minute power-off reset, and schedule a visit if the code returns.
A Maytag dryer that does nothing is usually a power, lock or latch issue before it is a broken part. An electric dryer draws on two breakers or fuses and needs 240 volts, the Control Lock may be on, and the door may look shut without latching. Check these, then book a technician.
Book a diagnostic for your model, done at the machine.
Office details, and the entry information to pass along.