Inside the appliance
Cooktop radiant element. In plain English.
Each radiant element under the glass of a Maytag cooktop cycles itself. Product Help credits a limiter, active even on HI, with protecting the ceramic, and that low settings, simmer and warming zones may not glow red at all.

Where it fits.
Cooktop radiant element in the appliance
The elements are beneath the glass cooking surface.
This image is an example of the component type. It will not tell you which replacement is right for your model.
How you can tell this system is asking for attention.
Cooktop radiant element trouble can show up along with weaker performance or a code that keeps coming back. It takes testing to say whether this component is the reason.

Maytag electric cooktop beeping
A Maytag electric cooktop that keeps beeping may have something on the control area, Control Lock being turned on or off, or a utensil left on an element too long. Clear and wipe the control panel first. Beeping for more than 15 minutes locks the panel and can show F1E0 on some models.

Maytag electric cooktop will not turn on or heat
When a Maytag electric cooktop will not turn on or heat, Product Help points to Control Lock, no pan detected, a pan too close to the controls, the automatic shutoff after long use, or the wrong cookware. Unlock it, recenter a suitable pan, wait for the shutoff to clear, and book a technician if nothing responds.
Owner care, within the model instructions.
Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.
- 1
Expect pulsing
Cycling at HI is part of normal operation.
- 2
Do not judge by glow
Part of an active area can stay dark, and a warming zone seldom glows.
- 3
Look at Control Lock
If nothing heats, make sure the lock is released.
- 4
Check supply
See whether a breaker tripped or a fuse blew, then de-energize the range circuit for sixty seconds and restore it.
- 5
Respect leftover heat
The glass stays hot after an element switches off.
Cleaning or replacement?
Leave internal testing to a technician.
Nothing heats after the lock, breaker and reset checks.
A single area stays cold.
An F code shows over a dead area.
Arrange a diagnosticSources and model boundaries.
These sources stand behind the Cooktop radiant element advice. Read the manual for your own model.
- Smoothtop Radiant Cooktop Element Cycling On and Off - Product Help | Maytag
- Element(s) Not Working - Glass Cooktop - Product Help | Maytag
Follow the guide for your own model, and see how we research these pages.
Should a smoothtop element switch itself off?
Yes: a limiter cycles it, HI included, which Maytag says guards the ceramic top.
Why is there no red glow on low?
Warm and simmer settings hold heat without glowing.
Can a lock explain a cold element?
It can. Control Lock stops unintended use, so release it first.
Is the glass cool once the glow fades?
Not necessarily; it can stay too hot to touch.
Maytag codes, symptoms, parts and service
From the message to what you do next.
Maytag electric cooktop beeping
A Maytag electric cooktop that keeps beeping may have something on the control area, Control Lock being turned on or off, or a utensil left on an element too long. Clear and wipe the control panel first. Beeping for more than 15 minutes locks the panel and can show F1E0 on some models.
Cooktop repair
Book a diagnostic for your model, done at the machine.
Find your metro
Office details, and the entry information to pass along.

