Inside the appliance

Freezer door seal and lock. In plain English.

On a Maytag upright freezer, the door seal holds moist room air out. Product Help links a leaky seal to frost, longer compressor runs and a warmer cabinet. It also flags the key lock: frost or debris packed into it can stop the door shutting all the way.

Last reviewed

Hand holding a blank sheet of paper against the gray rubber gasket on the hinge side of an open upright freezer door
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Where it fits.

Freezer door seal and lock in the appliance

The seal rings the door edge, and the lock sits on the door front.

This image is an example of the component type. It will not tell you which replacement is right for your model.

Owner care, within the model instructions.

Power the machine down and pull the plug ahead of any check you make yourself. Beware of pooled water and sharp bits of debris. Never handle a wet plug or electrical parts, take off a service panel or go beyond what your model’s owner guide permits.

  1. 1

    Paper test

    Close a dollar bill or paper strip in the door and pull on it; resistance means the seal is touching. Test the whole perimeter.

  2. 2

    Work the lock

    Turn the key while holding it in place; the lock is spring-loaded. Clear any frost or grit, then unlock, open, close and lock again.

  3. 3

    Level the cabinet

    With a 1/4 inch hex driver, turn both brake feet clockwise by the same amount to lift the front.

  4. 4

    Check what is inside

    Shelves, baskets or tall packages out of place can keep the door from meeting the seal.

  5. 5

    Look for shipping leftovers

    On a new freezer, remove any packing material near the door.

Cleaning or replacement?

Leave internal testing to a technician.

The strip slides free with no drag at several spots.

Frost returns although the lock is clear and the door closes.

A level freezer's door still refuses to close completely.

Arrange a diagnostic

Sources and model boundaries.

These sources stand behind the Freezer door seal and lock advice. Read the manual for your own model.

  • Door is Not Sealing - Forming Frost - Upright Freezer - Product Help | Maytag
  • Lock Preventing Door from Sealing - Upright Freezer - Product Help | Maytag
  • Not Freezing - Door is Sealing - Upright Freezer - Product Help | Maytag

Follow the guide for your own model, and see how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
How can I test the door seal?

Trap a dollar bill or paper in the closed door and pull. Drag means contact; check every side.

Could the key lock keep the door ajar?

Yes. Frost or debris in the lock can hold the door open slightly. Clear it and relock.

Why level the freezer?

A freezer standing crooked can be hard to close. Both brake feet turn clockwise to raise the front.

What does a bad seal lead to?

Per Maytag, moisture and air get in, frost builds, and the compressor works longer.

Let’s take care of it.

A full hamper waits for no one.
Book the repair.